How to propagate juniper

How to propagate juniper

Evergreen juniper is very decorated with any garden plot or a seamless territory. Usually people buy a young juniper in the market or in the garden center and plant it on the flowerbed or along the track. They pay pretty decent money for a modest chopper with two or three branches. But it turns out that juniper is quite easy to propagate independently - you just need to find an adult healthy bush and use it as a donor uterine bush.



1
Types of juniper

Juniper is dwarf, medium and large. The branches can be located:

  • along the surface of the Earth (horizontally) - such plants are called fluttering;
  • directed up from the Earth (vertically) - such plants are called reprehensive;
  • it is chaotic around the trunk (in the form of a dense mass) - such plants are called spherical.



2
Types of reproduction of juniper

Non-professional gardeners, namely, it is possible to name any dachank, prefer to multiply juniper in two ways: grooves and cuttings. Professional gardeners working in special nurseries use and vaccination method. But since it is quite laborious and without special knowledge to use it very difficult, we will not consider it.

3
How to propagate horizontal juniper by guts

This method works well only on horizontal views of juniper. We start to do the spring, as soon as all the snow and the soil can die under an adult bush a little.

  • Choose several twigs located near the Earth itself. These branches will be called gag.
  • At the bottom of the twins, remove all the hive at a distance of 4-5 cm from the base of the tank. The base is the place in the center of the bush, where the branch is growing from.
  • In the area of \u200b\u200beach specific land, the land is well burst, moisturize and plug a little peat. Peat is needed to create an acidic medium that juniper loves.
  • Tilt the first twig close to the ground and pinch it to the ground with a metal bracket. Make a bracket from thick wire.
  • A place where the jacket turned out to be fixed, suck extra earth. You will get an earthen hormic, covering that part of the branch where you from below removed a cheva.
  • In the same way, do it with all the prepared letters.
  • Watch that earthlings are constantly wet - regularly water them.
  • After one and a half or two months, you dig one hollyk and make sure that the root rose down at the bottom.
  • Separate the branch from the uterine bush with a secaterator or a special little hacksaw.
  • Gently dig the grooves so as not to damage the roots.
  • In the same way, separated from the bush, all the chains and dig them out of the ground.
  • Put the challenges in those places where you planned new juniper bushes. Landing immediately after separating branches with roots from the uterine bush.

If you separate the drains from the donor's bush in June, then by August they will come down at their permanent place. For the first winter, young juniper bushes, cover the huskien or any dry grass.

4
How to propagate the horizontal, vertical and ball-shaped juniper with cuttings

The reproduction of cuttings can be done from spring to autumn. But autumn shots implies the landing of young bushes not in open soil, but in a pot and with its further winter storage indoors.

  • On an adult uterine bush, choose a mature branch with a young top. In this twig, the so-called "heel" should be clearly visible - this is the place of adult branch and grown out of it a young process.
  • Sharp the garden knife cut the cuttings under the heel, retreating down 2-3 cm.
  • In the area of \u200b\u200bthe heel, remove all your cheva - 2 cm down, and 2 cm up.
  • Cutchens put in a wooden container with such a soil: 1 piece of river sand and 1 part of peat. Watch the whole piece of cutting without needle in the ground. The branch in the ground put a little obliquely (approximately 60 degrees). In the container, be sure to make drain holes.
  • Pour the cutter with water in which, add sodium or heteroacexin humate - these are special substances to accelerate the formation of roots.
  • Container Install to the greenhouse. In the greenhouse, provide a constant temperature around 16-19 degrees and quite high humidity. Regularly water the sapling.
  • When the cutlets come true, you will see new scrubbing kidneys on his tip. At this time, the temperature in the greenhouse will increase to 25-26 degrees.
  • After 10-15 cm of new needles grow on a cutlets, land the stalk to the ground at a permanent place. You can do this only until August, so that Juniper managed to adapt in the open soil.
  • For the winter, young bus will surely warm the cheese from ate or other similar material.

When planting a young juniper on a flowerbed, try not to damage the roots. He is very fragile and brittle. To do this, remove the bug from the container directly with the soil, and dig up from the ground with a large earthen room.

Add a comment

Your e-mail will not be published. Mandatory fields are marked *

close