Masters often have to deal with the problem of holes in the wall. They can be small from the pulled nail or large when a solid piece of putty or plaster disappears. Below will discuss how to cope with the task of deliverance from the hole and how to close the appeared defect.
Building materials for troubleshooting
Holes in the wall and ceiling during repair, this is a common thing. Consider how they can be seeled. Regardless of what your walls are made (ceiling): concrete, brick, plasterboard, to get rid of holes on these surfaces are used:
- Acrylic sealant. Used to get rid of small holes on any surface. With the help of a gun, the composition is applied on the hole and compared with the surface. The sealant should be necessarily acrylic, as with silicone perfect embelling it will not work.
- Solution (cement + sand + water). They close and large and small holes. Used to work with concrete and brick walls.
- Putty. It copes perfectly with the task of hiding small and medium holes. You can use on any surface. Ideal for drywall.
- Mounting foam. It is most common to fill the hole cavity. After leveling, cutting the bulges, and on top shit to perfect evenly. Mounting foam perfectly "cuts out" when closeing in large angular cracks, large holes in drywall and holes in hard-to-reach places of walls.
- Putty. Soviet tool that "caught" wooden windows. It can be used in "Fight" with small holes in drywall, concrete, in the joints of brick walls.
How to chose a small hole in the wall with undergraduate agents?
If during cosmetic repair or permutation you have small holes in the wall from the unsubstantiated screw or when the furniture is transferred, you made a small crack in the wall. Then, see below the recipes, how to get rid of such "troubles."
- Toothpaste. Little hole in the wall fill the toothpaste, squeaking it from the tube. Spade well to align the surface and give an improvised smear drying.
- Soda + superchalter. Super jackets mix with soda and fill the hole in the wall. Convenient to work to use a toothpick or cotton wand. When the composition gets dry, it is necessary to glue the surface to align it with the wall.
- Laundry soap. This is the old "grandfather" way. It is necessary to wet a piece of household soap, and to lose the place where a small breakdown was formed. The wet composition will score a crack or a small hole. After drying, the wall will be like new.
How to close a big hole in the wall with prudial means?
It is necessary to encounter not only with small holes and cracks, what to do if the hole in the wall of decent sizes, and the putty and the plaster you do not die? There is also a way out of this position. From cardboard (boxes from under technology) Cut square, slightly more than the hole itself. In the center of the cards, write two holes and stretch the sewing thread through them.
Now prepare the makeup for smear:
- 1 st l flour;
- 1 hl salts;
- Water.
Mix the ingredients to a porridge state.
- Take care of the hole. Place the cardboard in the hole, make sure that all its edges are inside it.
- The ends of the threads should be on the outside.
- Now, holding the cardboard for the threads (so that it does not fall into the hole in the throat) to make the prepared composition of the junction of the cardboard and the wall.
- When the design gets up, and the cardboard will be fixed, pull the thread and pass the mixture of soda and flour over the entire surface of the cartons, junctions and edges of the wall.
- When everything gets freeze, the place where the hole was, it will be necessary to stall.
0
2004
