How to seal an inflatable mattress

Troubles occur in the country. According to the eternal law of the meanness of the hole on the mattress, it is found before traveling to the sea. But it will turn out to be quickly and reliably seal.

We take glue - water -repellent and suitable in its properties to the material of your mattress. When buying a composition, keep in mind that the vast majority of inflatable mattresses are made from PVC (polyvinyl chloride), which means that the glue is needed appropriate. The one that does not spoil the material of the mattress, but firmly glue it with a patch and will not allow air to go out. For repair of the PVC mattress are suitable: Cosmofen, Tangit, Gebsoplast, Fenoplast or the domestic moment - everything for repairing PVC products, or universal. But if your mattress is still from another material, it will not be out of place to consult the seller.

We take 2 syringes with the thickest needles through which glue can pass; a patch of material similar to the mattress; soft sandpaper; acetone; Feng and a couple of cotton sticks.

We degrease the surface of the mattress at the place of detection of the hole, outside and inside. Outside, we will use a cotton swab. Inside, based on the size of the hole - a cotton swab or syringe. Folder paper is slightly scratched with the surface of the mattress around the hole and the patch on the side that we glue to the mattress - so the clutch of two surfaces will be better.
We dry and warmly warm the damaged surface of the mattress with a hairdryer, do not heat it stronger than the degrees 60-65.

Glue2

Pour the glue into the syringe - do not do this through the needle - otherwise the glue will simply freeze in it. We inflate the mattress of 80 percent and drive the glue inside the syringe. Let us dry.