How to dock linoleum

When laying linoleum at home, the most difficult task is to combine its edges. After all, the strength of the canvase and the service life will depend on the care of your efforts. Cold Welding, described in this article, is most suitable for Linoleum from PVC and less - a canvas with a heatel or a harness base (seam in this case will not be so beautiful). For a new flooring, class A glue is used, and more thick class C - for old linoleum or wide seams.

The following tools will be needed for work:

linoleum;
painting tape;
double sided tape;
glue class A or C;
special knife for linoleum (or stationery with climbing blades);
protective gloves.

Clean the bog between the edges of the linoleum from the garbage and make sure that there is no moisture. Bilateral scotchop attach the inner side of the linoleum to the floor, and the painting ribbon over the top curtain the coating along the entire length - this will ensure uniform adjacent of the edges. When docking the old linoleum and the use of class glue with tape can not be used.

Start cutting the tape and at the same time deeply fill the formed by the glue space. Do not apply a large number, it should only slightly act on top of small tubercles.

After 20 minutes, when the composition hardens, you can remove tape. After the final drying of the glue, consider it the remnants of a sharp knife.

After reading this article, you will make sure that there is nothing complicated in the docking flooring - the main thing is not to forget to wear protective gloves and ventilate the room well. And Linoleum will serve you faithfully for more than 30 years.