Tensioning the decorative canvas on the ceiling modules, installers often spoil the walls. The sad experience made the domestic masters succeed in self-installation. Those who wish to learn how to make simple recommendations. They advise qualitatively to prepare the surface (sshkurin, filling the foam slots) and choose the system of action only of the following five.
1
Stocked technology. We find the zero level of the room and note its location around the perimeter, as well as determine the lowest angle and put the point with a quench of 2 cm. Wash the rail: if it is too long, the processing angle is half the standard angle of the room; When the baguette is short, one edge of the base profile is removed under 45 °, the other - rejoicing Under 90 °, optional - on the contrary, then the details are glued. The carrier part (marked at the factory) is attached to the lower corner of the room, the remaining diagonally and sides are joined by zero projections.
2
Cartoon (French) scheme. Pubinate on the upper perimeter of the box holding a strip of hard plastic, aluminum or introduce it into special holes (if available plasterboard Figures). One end of the hook cannon is inserted into the plate, the material is heated, another edge is fixed on the opposite side. The sides are also fixed, do not forget to snap snapping every time "Garpun". Upon completion of the arrangement, the surface before the disappearance of defects is rehearsed. After cooling, a decorative baguette is placed.
3
Congraine technique. Installed as described above, fastening base. The canvas is taken, which will be 10-15 cm already than the ceiling. Putting the edge of the material to the fixing plate. The cloth warms, having achieved the necessary parameters. We press its ends with a second bar, slightly smaller in size. It is thoroughly understood how to mount the stretch ceiling "in Dutch" will help the study of the principle of snapshoting of the face. The final step is cutting off the construction knife of protruding pieces.
4
Cutting and wedge versions. Main task: Carefully fix the cloth in a plate holding with special fasteners. The spacer profiles are simply driven into the appropriate grooves. The cams are completely squeezed, the tips of the material are pushed between them with a spatula, then the spatula is cleaned, the spring of one of the devices is compressed, and the mechanism captures the edges. Over time, the movable and fixed (volume and empty) parts are connected rampant, which warns the breaking.
The basics of implementing all technologies are one. Elements join the walls with self-tapping screws, dowels, " molly" (for GLC). Before fixing the ceilings, it is necessary to heat the fan heater to + 40 °, the temperature of the canvas is adjusted to + 60 °. The film is first fixed from opposite sides, fabric - on the sides.
0
1099
