How to put plasterboard

Plasterboard is convenient for its use due to high ecology, the effective ratio of the complexity of the work and the value of the material and ease of use. Plasterboard is usually used to align ceilings and walls. The putty of plasterboard is primarily necessary for uniform wall decoration. All irregularities, defects and flaws can be easily eliminated using the putty method.

1
How to put plasterboard - choose a mixture and tools

To apply a special mixture, use a tool called a spatula. For large areas, it is better to use a wide spatula.
To prevent the occurrence of cracks in the locations of plasterboard sheets, we purchase a reinforcing grid to strengthen the layer of putty.
There are various types of mixtures, both dry and already mixed with water. They differ in fine / large graininess of the substance.
To eliminate coarse defects (seams, traces of self-tapping screws), choose an alignment mixture, it has larger particles.
After the leveling mixture, we use the finish putty, which gives the surface smoothness.

2
How to put plasterboard to put the drywall - shocks

We prepare the mixture according to the instructions. Immediately we do not apply, let it brew 5-10 minutes for thickening.
Cut a chamfer at an angle of 45 degrees at the edges of the plasterboard.
The location of the cut is revealed by primer.
The chamfer should be big, do not chase for beauty and do not be afraid to cut more than you need.
Fill out a slice with special glue (it is possible that used when installing drywall) or putty.
Introduct the joint with a special grid until the glue was frozen.
Align the remnants of the substance and wait for drying.

3
How to put plasterboard plasterboard - trim corners

The putty of the inner angles is based on the same scheme as working with joints.
Cut off the chamfer, fill in glue, we put the reinforcing mesh, align the surface with an angular spatula.
For outer corners, it will have to be resorted to the use of counteroles (aluminum or plastic corner with holes).
The binder itself is applied to the angle (glue or putty), after installing the contraly.
After installing and drying the substance, the area is putty.

4
How to put plasterboard plasterboard - walls and ceiling

For a uniform surface, it is possible to take several layers of putting out putty.
We apply a mixture with a thin layer on the walls and the ceiling with a special tool - spatula.
The technique of applying is simple, but the time will need to adapt.
Everything needs to be done gradually, do not put a putty with a thick layer, otherwise you will have to get a hill created by your own hands.
We remove small irregularities and influx by the abrasive grid.

The putty serves not only to align the outer surfaces. It also has protective properties. In the case of another repairs, when dismantling the old impact, removing the putty layer, you will save the reliability and quality of drywall.