A person is constantly facing the problem of lack of housing, and if nothing can be done in the apartment with this, then in a private residential building it can be solved using an extension. The process of erection of the walls of an extension is the same as everywhere, but the installation of the roof has some features.
1
Before starting work, you should decide on the type of roof that you will build. Single roof is recommended to use in an unheated room, the temperature inside which does not have much importance for you, for example, in a garage or gazebo. If you add a full-fledged living room, which must keep warm and have a attic - a row roof is best suitable for you.
2
Installation of a single-table roof does not pay any difficulties and can be made by you yourself. Such a roof is a rafting system, covered with roofing material. Start it by calculating the inclination of the roof. Knowing this magnitude, you will understand which level of walls are necessary for your extension. After their construction, start to put rafters. It is necessary to mount them evenly all the roof at a distance of 60-70 centimeters from each other. When they are ready, proceed to laying roofing material. Due to the fact that from the ground, the surface of a single-table roof is practically not visible, inexpensive materials, such as rubrojord or ordinary slate, can be used as a roof.
3
The construction of a duplex roof will require you a lot of time and strength. Works start with the installation of the so-called tank beams. To build them, use a bars of 150x100 millimeters, installation step - 60-70 centimeters. One end of the beam falls on the wall of the extension, the other is attached to the wall of the house. As a fastener, use nails or screws with a length of 10 centimeters, as well as metal brackets. After laying the beams, go to the installation of the solo system. As a material for their manufacture, the bars of 100x100 millimeters are optimally suitable. The distance between the raps is to withstand the same as between the beams - 60-70 centimeters.
4
The next step is to install the crate. As a material, use the boards whose width should not be less than 5 centimeters. The distance between the elements of the crate depends on the type of roofing material, which you will use, for example, for the tile it should be 10-15 centimeters, and for slate can reach 50-60 centimeters. Do not forget about heat and waterproofing. The right choice and laying of these materials will help you significantly increase the thermal insulation properties of the future roof. Laying the roofing material and the installation of drainage are the last step in the process of building the roof of the extension.
5
Depending on the appearance of the house, both single-table and the bartal roof of the extension can be installed in several ways. The easiest and most reliable way is the installation to the frontoth of the building, in this case, both will have a common skat that minimizes the possibility of leakage appearance in the future. In case of building a double roof, you will not hide without additional endands or oscillates. The duct recommends that the roof of the main building - it will preserve its integrity and avoid disharmony in appearance.
Owning outlined above information, you can not only build an extension to your home, but also to make a roof for her on our own, while retaining the overall architecture of the structure and saving on the call of the editor's brigade.
0
1660
