The sacred houses have excellent thermal insulation properties, but they quickly settle and lose their aesthetic appearance. In order to extend the life of sacred houses, maintain the structure and prevent the full ruoustener of the structure, the walls are strengthened with bricks. How exactly the technological stage is happening, look further.
1
Before proceeding with construction work, make a construction estimate in which you carefully calculate the number and type of the required building material. So, in any case, each of the presented components will be needed when the walls are lined with bricks. Building materials and tools for working with the facing of the old house: bricks, cement, sand, insulation, water, plumb, level, bucket, shovel, concrete mixer (you can knead a solution for masonry manually, then it will take a spacious trough).
2
If you intentionally build a house from Samana, after construction, let the walls settle (naturally) and stand for several years for subsequent strengthening and prevention of the foundation. For such a period of time (3-4 years), the walls are quite strengthened and will be prepared for further action.
3
If you have so formed the circumstances that you have acquired your own country area in addition with the old globbit imminent house, do not be discouraged and do not take cardinal solutions. In most cases, the situation can be corrected. It is enough to strengthen the angular joints of the construction and fill the foundation. Short description How does this happen:
It is necessary to drill holes, a diameter of 12 mm and a depth of 100 mm, into concrete (or 200 mm in a brick) with a slope of 15-20 degrees;
In the well-done holes immersed fittings in 12 mm. The remainder of 150 mm of length should go to the surface of the foundation;
Pour a new foundation of 30 cm and leave an anchor in concrete;
Perform waterproofing from a two-layer runnerdoor.
4
After the question with the foundation is exhausted, do not forget to raise the base (if you didn't do earlier) - perform a formwork and fill it with concrete, or as an option - lay out the brick.
5
Getting Started by the walls of the walls, perform an exemplary calculation of the brick - at the most inopportune moment, the stock of the building material can run out, delivering extra trouble. Put the "fitting room" series without using a binder - dry. On average, brick consumption is 55-58 pcs. US 2. Think over the ventilation system and do not put brick on the walls to the walls, leave the space for the air exchange. The absence of the possibility of caring wall will result in their rapid destruction, dampness, spread of mold and fungus.
6
Do not forget about the ligament of the walls. You can use a single 10 cm of nails as a connected material. The formed gaps would not be bad to fill out by non-cement mortar, but the heat insulating mixture (for example, clay).
7
Cement mortar for masonry walls Prepare in the ratio of 4 sand buckets on 1 cement bucket. After careful mixing, add water to the average consistency ("sour cream"). In the process of masonry between bricks, it is necessary to leave the seams in 11-13 mm.
8
Metal jumpers are on the door and window peres. Maximum strength and minimal gap allow them to be used as fittings.
9
Bricks need to be laid in a chess and regularly check the walls on "evenness" using a level.
Construction and repair of the house requires a lot of expenses. Drawing up the estimates will allow you to accurately calculate the amount and cost of the required material. Plan your expenses. Buying brick, Consider the reserve at least 500 pcs. additionally. Everything happens, and the building material will not disappear, as a last resort, apply for another need.
0
3812
