The cabinet has always been the most noticeable and important subject of the interior. It stores the mountains of things huced by people in life. Over time, not only people are progressing, but also furniture. The vertex of the evolution of cabinet furniture is so popular in our time wardrobe. Its main feature is sliding doors. It is they who allow you to save our living space. The advantages of the built-in wardrobe mass, the lack of one is expensive. You can fix it by making a wardrobe with your own hands.
1
Before you start buying materials and accessories, decide on the cabinet model. On the Internet, in magazines, pick up a suitable instance, add your imagination and taste. V internetmany who have already done the closet, lay out photos, blueprints. Now that you know what you will build, go to a specialized store and buy materials. You will need:
door canvases (laminated chipboard or painted MDF plates);
slot roller;
plasterboard;
dowels, selflessness;
rubber gaskets;
metal profiles and corners;
rods under the shoulders, rod holders;
handlengths, to install shelves in the middle;
instruments.
2
Select the location of the built-in wardrobe. Check the selected location - the floor and the ceiling must be parallel. Wall align the cement with a solution if necessary (check with the help of plumbers). Now mark the location of the sliding door guides and side surfaces. Apply all the dimensions of the future cabinet to the drawing. If the cabinet is planned inside the cabinet, then mark it on the wall.
3
You can start mounting a wardrobe. Frame mounted from metal profiles. The side surfaces can be collected on the floor of two or four slats, and then, when the walls of the walls are ready, attach them to the wall with self-draws. It can be done differently - immediately secure the side planks to the wall. Mark on the floor of the center of the built-in wardrobe. All marking check the plumb - they should be strictly vertical. For reliability, attach the design with dowels to the floor and ceiling.
4
Make the door frame from the rail. Cut the material for the side surfaces to the desired size and attach the prepared sheets to the side walls of the cabinet, secure the corners. Wires for lighting output. Bottom and on top of the door opening, fasten the guides. Get the door in them. Set the rollers - the lowest door of the cabinet door, small - at the top. Inside the cabinet strengthen the rod under the shoulders.
5
The inside of the cabinet is divided into the desired number of sections - usually it is 2-4. Install the desired shelves. Attach the frames for installing drawers. Finish the built-in wardrobe purchased fittings. In order for the doors, slamming do not knock, put rubber gaskets in places where the door canvases are adjacent to the side. Lock the doors with special door magnets. Spend light.
Pay special attention to the quality of door canvases. If after short-term exploitation, they were "led" or quicked up, the use of the cabinet will become difficult. Installation of glass or mirror doors canvases better entrust to specialists.
0
1809
