How to make a knife for a knife?

If you have a blade from an old knife, then do not hurry to throw it away, because it can be made of various materials for him.

1

How to make a knife handle from textolite?

For the manufacture of a knife for a knife from the textolite, we will need:

• textolite;
• sandpaper;
• hacksaw;
• drill;
• bolts with nuts;
• pencil;
• rivets;
• file.

Production:

• On textolite, pencil draw the desired shape of the handle. If you have an old handle, we apply it to textolit and supply a pencil.
• We cut down the metal from the textolite two halves of the handle.
• We apply the blade on the dried handles and we drill three holes, with a diameter of 4 mm.
• In the holes insert the bolts.
• We screw the halves of the handle to the blade.
• Processing with a handle with a file.
• We unscrew the bolts, pull out the blade, steamed chamfer on the handle.
• We grind the blade if necessary.
• Razzenka holes for 1 mm, using a drill of 6 mm.

• Insert rivets into holes.
• We rush the knife knob into a single whole. Do not worry about the fact that the handle will crack in physical effects, since this material is very durable.
• The final stage, we calculate the handle with a file with an emotion paper.

The knife for the knife from the textolite is ready!

2

How to make a knife for a knife from Beresta?

For the manufacture of knobs for a knife from Berestov, we will need:

• beresta;
• glue;
• clamping vice;
• bulgarian;
• wooden shelter 5 mm thick.

Production:

• In two wooden parses in the center we drill holes, such a diameter so that the steel knife handle passes in them.
• Cut out small squares from Berestov so much to cover the entire length of the handle.
• Drill a hole in each square bark in each square.
• Place on a metal handle first wooden bar, then the squares of Beresta and in conclusion, the second wooden bar.
• Introduce the Beresto glue, then we give adhesion a little silent. After the glue with Bershest grabbed, remove the block of Beresta and press it in the vice.

• Making sure that the glue is completely dry, proceed to the shaping of the knife handle.
• Grind the knife handle. To do this, use the grinder with the grinding wheel. Initially, attach the handle of a square shape, then an oval shape.
• To make the final appearance of the handle, polish the knife handle.

The handle for the knife of birch bark is ready!

3

How to make a handle for a knife from the traffic jams?

For the manufacture of the handle of the congestion, we need:

• traffic jams;
• stationery knife;
• needle file;
• pencil;
• drill;
• glue;
• bolt and nuts.

Production:

• Corks of champagne or wine, cut stationery knife at the washer to 1 cm.
• Pencil mark on each washer center.
• Drill holes are drilled into the washer with the traffic jams.
• We put on a pin cut traffic jams.
• We stick together and plug anchoring nuts on both sides.

• Once the glue is completely dry, hold impaled on a pin in the cork drill and proceed to handle the processing.
• Turn drill handle and process a file from the traffic jams. We attach the handle desired shape.
• Ready to sit down on the handle of the knife jams.

The handle of the knife jams ready!

If your knife handle has broken, or just tired, do not rush to throw the knife. After all, for the handle of the knife can be made of different materials that you have in stock. Homemade handles for knives look very stylish, and also can make the desired shape of the handle.