Spinner is a very popular thing among adolescents and adults. It helps concentrate thoughts, relax, remove psychological tension. You can buy a spinner in almost any store, but much more interesting to make it yourself. Below will be the instruction on the assembly of different spinners with your own hands.
How to make a spinner do it yourself - a simple spinner
In order to make a simple hand, the following materials will be needed:
- 5-6 bearings.
- Screed.
Making the following simple actions:
- We decide the bearings in length, closing tight towards each other.
- Connect 3 ties in the form of a triangle.
- We dress the figure on bearings from the screed.
- Tighten the bearing with one of the sides so that they make the bearings tightly. Cutting sticking tails. The resulting design should be similar to the caterpillars.
- We take another 2 ties, tighten them vertically, along the edges of the second bearing. Cutting sticking tails.
Spinner is ready.
How to make a spinner do it yourself - spinner-star
In order to make a spinner-star with your own hands, the following materials will be needed:
- 4 bearings.
- Super glue.
- Threads.
- Sandpaper.
- Soda.
Making the following simple actions:
- We fold the bearings as follows: two bearing are vertically tightly tight to each other, the rest are two - on the sides of the second vertical.
- Stripping the spinners with sandpaper in the place where we glue.
- We glue the spinners in the form, which was determined initially, sprinkling the place of gluing soda for greater strength.
- Bearing connections with threads.
- Also, the super-glue on the threads so as not to be opened.
- Spinner is ready.
How to make a spinner of wood with your own hands
In order to make a spinner of wood with your own hands, the following materials will be needed:
- A piece of wood.
- Drill.
- 3 bearings.
- Sandpaper.
- Pencil.
- Saw.
Making the following simple actions:
- On a piece of wood put three bearings, at an equal distance from each other.
- Pencil supply bearings.
- We connect the resulting circles so that the figure with the shape of the caterpillar is turned out.
- We depart on the floor of the centimeter from the caterpillar and the shaft form of the future spinner.
- Drill circumference with the calculation to ensure that bearings were tightly.
- Cut the resulting figure.
- We discover the resulting form by sandpaper, get rid of sharp corners and the zoom.
- Insert bearings.
Spinner is ready. If you wish, you can always paint it into any color using a spacing.
0
664
