How to make Rashalovka

Cancer traps are of different designs. The most popular is cone.

1

How to make a ricolovka from the construction metal mesh

It will take:

• construction grid;
• metal scissors;
• knitting wire;
• pliers;
• marker;
• roulette or centimeter.

Production process:

• Standard width of the construction grid - 1 meter. Unwind the roll, and measure another 80 cm length.

• We cut off the scissors for metal the desired piece.

• We turn the grid into the cylinder.

• "Stitch" two sides with small pieces of wire. Split wire needed as close as possible so that our design does not hang out. The more bonding points - the better.

• After the grid cylinder is fully prepared, measure its diameter. If you adhered to the proposed sizes, it will be approximately equal to 25 centimeters.

• Now we take the mesh roll, retreat from the edge of 25 cm.

• And with the help of the marker and the measuring tape, we delineate the semicircle with a radius of 50 cm, and cut it with it with metal scissors.

• These billets need 2, so it is immediately necessary to make the second in the same way.

• Now it is necessary to outline another semicircle, with a radius of 5-7 cm on our billets, and also cut it with metal scissors. It will be a hole through which raks will fall into the trap.

• Twisting our semicircular blanks in the cone.

• "Stitch" with pieces of wire.

• After that, it is necessary to insert the resulting "watering cans" into the cylinder, and fix them all the same knitting wire.

• The manufacture came to the final! It remains only to cut in the side wall of the cylinder of the window, through which you will get crayfish and lay the bait.

2

Cone Raskolovka

To do this, we need:

• mesh with small cells;
• wire (diameter 4-6 mm);
• capron thread;
• plastic clamps.

What do:

• First we make two metal rings of different diameters: the lower - 40-50 cm, the top - 15-20 cm.
• Then attach the grid to the bottom ring using the clamps or the caprony thread (all over the ring every 5-6 cm).
• Next, we prepare three the same wire struts. The diameter of the wire used for them should be less than the diameter of the wire rings
• The struts must allow to place the upper ring at a distance of 14-18 cm from the bottom ring. For more convenient transportation of such a device, one of the struts can be made removable.
• After installing the struts, we are tightening the sidewall mesh traps, then attach the grid to the upper ring, adhering to the distance between the clamps of 10-15 mm.
• Cut off the extra part of the mesh and get excellent Rashalovka.