How to make a groove

The joinery groove is used for attaching elements of wooden structures or tapping metal parts. Make a well in the wood can be a variety of ways and devices.

Chisel shock - an affordable and simple tool for groove sample. Using multiple tools with different cutter can do the dirty work and a precise fit connections. Any indentations in wood carried out on the same technology:

With the polygon, ruler and pencil groove contour is drawn. Front socket require marking on the reverse side of the workpiece.
The workpiece is fixed a clamp on the bench or in a vise, large boards can be fixed braces.
Scheduled perimeter prodalblivaetsya chisel, holding it perpendicular to the deepening and easy blows of a hammer on 2-4 mm, preventing cracking of the fibers.
Pieces of wood carefully selected, continued chiselling next layer and so on until the required sampling depth.

On the veneered surfaces facing slotted pre sharp knife in order to avoid its detachment.

The procedure for cutting chisel groove for door hinges:

Loop is put into place, marked in pencil ends.
And traits measured thickness and width of the incised part.
Cuts through the loop perimeter in a loop thickness.
Log-made fine fibers across the slot from one side to another.
Pruning wood from the edges, remove the waste.
Deepening matched either by marking the line and cleaned.
Checked slot compatible with a loop.

Deep groove make it easier if you first drill nasverlit holes smaller in diameter than the recess width. Then remove the chips and to align the ends of a narrow chisel, wide chisel to remove the excess along the long sides. Tool during chiselling holds a facet into the slot, and the blade is placed exactly on the marking line. Through holes are cut by about half, the preform is inverted and continues sampling at the opposite side.

Pages of angular compounds of furniture elements are convenient to perform universal consoles to the electric drills. Compact devices are fixed on a standard spindle, have depth adjustments and serve to make straight spikes or swallow tail connections.

The groove for fastening large boards or bars is performed using a disk saw:

The power tools cut the contreels along the edges of the groove and after 1-2 cm over the entire length of the chosen wood.
Small pieces of wood were crushed with chisels without any special difficulties, planes are aligned with an acute chisel.

Duties can also be made by ordinary hacksaw.

Use in the workshop of a manual milling displays the process of manufacturing grooves to a professional level. The tool provides the ability to perform a variety of propyl, recesses and recesses. Working technology depends on location, sizes and shape of holes. The selection of a simple groove is performed in the following order:

The detail is pressed against the vertical board with clamps.
A suitable cutter is inserted into the spindle.
The depth limiter is set.
In parallel, the groove guide is fixed.
The mill is lowered to the surface of the workpiece, the correctness of the settings is checked.
The working part is assigned to the detail, the milling mill starts.
After a set of revolutions makes the first passage.
Actions are repeated until the required depth and width of the groove are selected.