Drill is one of the most sought-after homemade master tools. She is indispensable when you make repairs in the house or crawl something. The drill can not only drill holes, but with the help of special nozzles to grind and polish. In skillful hands it can even become a small lathe. But in the process of operation, the drill may fail. And we tell you how to repair it.
1
Most often fault in your drill arise simple, and if you understand the electricity a little, it will be easy to eliminate them. Before repaid, prepare the necessary tool. You will need a simple and cruciform screwdriver, passatia, tester. When you start repair, do not forget to turn off the device from the network.
2
If your drill stopped working, do not hurry to disassemble it. Determine the malfunction by passing a chain from simple to complex. Check if the current disappeared in the outlet and whether the plug plug is. The plug can unscrew the screw and disconnect the wire, and if it is cast, it can simply be broken. Most often, the wire is rehearsed in the cable in the place where it enters into the drill. Take a cruciform screwdriver and unscrew the cover screws. Then the tester needs to call both cable veins. If a break was discovered, you can cut off the centimeters fifteen cables and connect it again, but it is better to replace the new one. Do not try twisting the cable, it is not practical. At the seat of the twist, the wire is reheared much more often.
3
If the cable is working, but the drill does not work, then look in what condition is brushes. Inspection can be made by removing the cover on the handle of the drill, or through the boiler window. If they are worn, then replace them with new ones, just pick up completely identical. When you take brushes, pay attention to what state is the collector. If he is very sad, then he needs to wipe with alcohol. Make a cotton swab, and smoem it, wipe the anchor collector. The alcohol dissolves very well and the nagar.
4
Determine whether the turning button is faulty, you need a tester. To do this, remove the cover on the handle and disconnect the button from the chain. On the button there are two channels for which the current passes. They have to be checked when the mode is enabled. If one of the channels does not miss the current, then the button is faulty, and it must be changed. Pick up absolutely similar to the old, if there is a difference, it may not be in your place. It is better not to touch the button itself, there may be a deformation of plastics, wear of small parts. This repair most often ends with nothing.
5
When an extraneous sound is heard from a drill gearbox, then you need to remove the drill cover and open access to the engine and the reducer, and then determine the malfunction. It is possible to replace the old lubricant to the new one, and if the gear was worn out - then put a new one, similar. Gears are removed very easily. They are simply inserted each in their landing place.
6
And finally, the most complex malfunction is the interstitious closure on the anchor of the engine of the engine. The first signs of closures are the appearance from under the brush of great sparking, accompanied by a crackling and smoke. Change the anchor in modern tremers is easy. When you remove the lid, then full access to the electric motor will open. Next, remove the brushes and remove the electric motor from the landing place. To remove anchor, it is enough to pull forward, and it will easily come out of the engine. Assemble in the reverse order.
As you can see, repair the drill is quite easy. Try, and you will succeed, you can save time on finding a master and pay for his work.
0
3892
