There is an opinion that connecting a telephone outlet is a simple job that everyone can do. Practice shows that it is erroneous. Everything is clear until the moment you picked up the outlet. Further problems begin. We will tell you how to properly lay a telephone cable, what types of telephone outlets are and how to connect them correctly.
1
Before starting work, you need to prepare the necessary tools and prepare materials. Of the materials, you will need a UTR-5 cable, which you will bring power to the outlet. The rosette itself and alabaster itself. The most popular of telephone outlets today is RJ-45. They are external and internal. Decide which outlet you will put, if internal, then you will need an installation underpass. From the tools, prepare a perforator, a hammer, tools for cleaning and squeezing wires, a spatula, screwdrivers.
2
The very first step is to bring the telephone cable to the place where the outlet will be. Lead it on the plinth or how wrong. It needs to be laid, like the wiring, for plaster. To do this, break the groove along the wall. First, lay the route and make sure that the strobe does not intersect with the wiring. In dubious places, you can check the presence of wiring using a receiver. The included device is brought to the wall, and if an electric wire passes there, characteristic crackling will be heard from it. Next, using a hammer or a perforator, make a tape and lay your cable in it. Light a groove by alabastr using a spatula. Alabaster grabs very quickly and it is convenient for them to perform such work.
3
Next, mount the socket itself. If it is external, then it is enough to fix it on the wall with screws. In order to install an internal outlet, you need to make a hole in the wall and install the installation undercut box there. The hole can be made using a perforator, a drill with a special crown, or if you do not have these tools, then use a hammer and a chisel. The hole is recommended to be done to the depth of the installation box. Then get the cable into the box, insert it into the hole and soak it with a alabastr. After the alabaster dries, install the telephone outlet itself. To do this, remove the top panel and use sliding mounting antennae, fix the outlet inside the installation box.
4
Then the insulation is removed from the cable and the veins are cleaned. With the help of squeezing, terminals are attached to the ends of the veins. In almost all sockets for connecting phones, only a pair of medium contacts, the third and fourth are used. Polarity is also basically not important, except for individual cases. If such a need arose, then just change the wires in places.
Having done such a job, you will have a high -quality telephone outlet and a protected cable not subject to external damage.
0
2103
