Wall lamps are designed to illuminate specific places or items. Illuminating the warm and cozy light zone of various destinations, wall scaves can also become a wonderful interior decoration. The installation of such lamps is quite simple, but it is desirable to have at least small knowledge in the electrician.
1
Take care of choosing a place for a wall lamp at the very beginning of the repair. Woods are usually installed at a distance of 110-150 cm from the floor, depending on the lighting purposes. For premises with high humidity, use only special moisture-proof lamps, set them at a distance of at least a half-meter from the moisture source.
2
Make the walls for the wires of the lamp. Having paved the wiring, cover the stroke, leaving the wires removed for the future lamp and its switch.
3
Some lamps have a built-in rope or pushbutton switch. In this case, simply pave the wire under constant voltage to the selected place. If the wires are removed in advance, this will significantly simplify the task.
4
Be sure to turn off the electricity before starting work. Disconnecting the automatic power supply of only the group line in which the installation is carried out, check in place using an indicator screwdriver, whether the disabled machine is correctly selected.
5
Unpack the purchased lamp. Look at the instructions for installing it. Attach the mounting panel to the wall and mark the place of space for drilling holes. The base is attached to the wall with a dowel. Make sure that the marked seats do not intersect with the paved wiring. Depending on the material of the wall, use a drill or perforator for drilling holes.
6
After installing the fastening base, cut the power wires along a length of up to 10 cm from the wall. Remove the first protective layer from the wire. Clean the tips of the opened wires by about 5 mm.
7
From the inside of the sconium, you will see a terminal consisting of two main parts - a terminal box, with wires connected to cartridges, and a housing with a protective rubber casing. Disconnect the body from the terminal and stretch through it the feed wire from the wall so that the ends of the wires come out of the plastic base. Connect and secure the wire screwdriver in the terminal. Zero is marked with the letter n, and the zero wire always has a blue color. The phase is indicated as l, the phase wires can have different colors. Never connect wires without terminals, wrapped them with a tape. This can lead to fire.
8
Secure the lamp on the base. Depending on the type of scave, tighten all the locking bolts, set the plants and insert the bulbs.
The installation of wall light luminaires will additionally highlight the selected area of \u200b\u200bthe room, without any dependence on the outlets. Competently dismissed light will give the desired view of the room and create the desired atmosphere anywhere in your home.
0
2644
