Bra - this is a wall lamp. They are intended to ensure local lighting on a certain area of \u200b\u200ban apartment or at home. Install the sconium at any home master. The light source is connected not only from the outlet, but also from a separate line.
1
First you need to choose the right lamp. They are now on sale a huge amount is represented. There is a scraper to illuminate a part of the room in a light light or on the contrary direction of lighting - for reading, etc. If you put a lamp in the bathroom or other rooms with high humidity, then buy necessarily in moisture-proof. Simple devices installed in such premises can not only spoil quickly, but will be dangerous for people located there.
2
Woods come with a built-in switch without it. In the first embodiment, it is enough to bring the wire and connect it to the specified terminals in the lamp. In the second you need to install the switch. Determine the place where you will stand the lamp, and where is the switch. Then the perforator, or if you do not have such a tool, then with a hammer and chisel, run the groove (stroke) for the wire to the distribution box. In place for switch, make a hole and place the installation box for the switch. In the stroke, lay the wire and squeeze all the alabaster. Choose the wire is not thick, just a cross section of 1.5 mm. Empty the phase wire through the switch, and zero and protection - directly. When you connect the wire in the distribution unit, it must be de-energized by turning off the automata.
3
Attach the bracket of the sconce to the wall and notice where there will be holes for fastening. The bar must be placed with such a calculation so that the plug-in the wire fit to the lamp vertically. Depending on what material of the wall, the mount is selected. If the walls are made of wood or drywall, then quite ordinary self-tapping screws, and if concrete or brick - you need to drill holes and secure the bar to the wall with dowel nails.
4
Next, divide the wire eagerly and remove the insulation from the wires of millimeters seven. Connect the wires to the terminal block according to the specified scheme. Special attention is paid to the protective wire, make sure that it is accurately connected to the lamp housing. After connecting the wires, the case is screwed with decorative bolts to the mounting bar, which is already fixed on the wall. Next is the mounting of the protect glass. Here almost every lamp need to be approached individually. The overall fastening is a plastic nut on the fixture chuck. Out it, put the glass and twist.
The last stage is a lamp selection. On the cartridge of the lamp indicates its permissible power. Follow this advice, and the lamp will last long. If you put the lamps of greater power, it will quickly come into disrepair.
0
3708
