How to make a wooden boat

Wooden boat - the pleasure is not cheap. But if you are ready to work hard, you can create your own river transport with your own hands, saving a decent amount.

Prepare a diagram or drawing indicating the size. Perhaps in the search engine of your browser on the request of a "wood boat scheme" among the proposed options you will find the appropriate, otherwise you will have to either combine the found options, or rely on yourself, or seek help from a specialist. According to the drawing, it is already clearly determined by the number of necessary materials.

For sides, select high-quality pine or spruce boards - wide and long, without bitch and cracks. Before the construction of the boat, these boards must be seen on a flat dry surface under the yoke. Immediately before work, carefully inspect each board for the presence of defects. Start creating a nose of a boat:

Source the desired length of the board, from the nose, scold the edge at an angle of 45 °, rush. With damned edges, remove the champecker so that when pressed the gap between these boards it was not. Cover these ends with a protective antiseptic.
Make the bottom of the nose of the boat - the triangular bar (its length is more than the height of the boat one and a half times). The bar need to fool and process the antiseptic.
Collect the "nose" of boats: two boards and the base lubricate with carbon black glue, firmly close with nails or self-draws.
Spire all protruding excess top and bottom

For the back side, pick up a 5-minute thick board. Drink the side sides of the side, and leave the reserve at the top and bottom, these edges will handle after the assembly. Prepare a strut - a solid board, the length of which should be equal to the maximum width of the boat, and the height almost coincide with the height of the sides, otherwise the side can burst when you bend them. To perform bending, the rope and two assistants will need:

Install the spacers in the place, assistants, slowly, with the help of the rope begins the side boards, and you apply the edges of the sides to the blank of the back side and make a mark on them, where and how much to remove the chamfer, so that all the details are connected without gaps, then remove the chamme Once again. Customize several times to exclude the gaps.
Treat the joints of the joints by antiseptic, secure the boards with joinery glue, as well as nails or screws.
Spile the surplus at the bottom of the rear side, place it up (arc, triangle, trapezing, straight).
Install constant struts and seats. Before fastening them, you need to make a small drill hole in the sides, so you will prevent the appearance of cracks.

Start creating a bottom:

For the bottom there will be a galvanism leaf. Set the boat at it down, circle with a marker with a marker of 1.5 cm and cut off the metal scissors.
Turn over the boat up "bottom", remove the chamfer from the sides and spacers from the side adjacent to the bottom. Treat edges by antiseptic. Wait until the impregnation and carbon black dressing.
On the lower side of the sides, apply continuously silicone sealant, put special threads or a pass on it in two rows, it will protect against the flow.
Squeeze and align the carved metal blank and attach it with galvanized screws with pressshaba or nails (1.8x32), moving from the middle of the boat to the edges.
In places where the metal performs more than 5 mm, do more superfluous. Along the perimeter, knock the hammer, flexing the sheet on board. Also protect the tinsel to the nasal part of the homemade boat, having previously treated it with a sealant and setting the thread.

To tin not thunder and on the bottom it was comfortable to walk, make the wooden flooring in the form of a boat sizes. To fasten the boat to the pier at the top of the nasal part, install a long bolt or stud, which have grown through the chain link. Boat Do two layers of antiseptics and paint (all, including galvanized).

This is not the only option to create a wooden boat with your own hands, but here the entire principle of operation and features of the creation of a swimming agent are revealed.