How to set up a Router Zyxel Keenetic 4G

Even if you have a contract with a provider to gain access to the network, without the correct setting up the router, it will not be possible to feel all the advantages of the service. Therefore, below we will describe in detail how the Zyxel Keenetic 4G is connected and configured.

1
Zyxel Keenetic 4G settings in Windows

This router knows how to work with various communication operators, including the popular companies of Intercom, MTS, YOTA, Megafon, Beeline and others. For service in some areas, a special firmware will be required, which you can get by consulting with technical specialists. When the device is completely ready, we connect it to the computer and the network:

If the instructions for the device are available, be sure to get acquainted with its contents. We connect the router to the outlet, we place the antenna cable in the USB connector, and we connect any of their LAN ports with a yellow cable to the network card of the system unit of our PC (or the corresponding laptop nest).

Next, it is necessary to adjust the TCP/IP parameters, indicating the automatic receipt of IP address values. For this:

open the “Start” and move to the “Control Panel” - ›“ Network Connections ”;
select “Connection by local network”;
we move to the “properties”;
click at the “Internet Protocol (TCP/IP)”, a new window will open;
we leave marks in the form of points opposite two choice options: “receive an IP address automatically” + “get DNS”;
in all open windows, click “OK” to save changes.

2
Setting up the Roter Zyxel Keenetic 4G through the web interface

The functions of the router itself are available to the user through a web interface, which is easy to open from a browser. To do this, enter the address of the address 192.168.1.1 and indicate the login \\ password-admin \\ admin (pass-code can be 1234 or other specified in the documentation). Further, we are welcomed by a page that will notify that the Internet is not yet tuned:

at the very bottom of the window, click on the “Web Configurator” button;
select “cancellation” for installing a new login and password;
we go to the USB tab;
click on the “Technology” link in the “Modems” section;
in the new window, we leave the daw in the points “Turn on” and “Use to enter the Internet”;
select the current communication operator and access point;
click “Apply”.

If everything is done correctly and the router began to distribute access to the Internet, a green icon depicting the globe will light up below.

3
How to set up a Router Zyxel Keenetic 4G, if you can’t connect

After the manipulations described above, our devices should earn in the usual order and assign the IP address to the computer. This can be checked in “Local network connections”. If there is a note “DHCP is assigned / turned on”, then the router successfully appointed the PC internal address (for example, 192.168.1.23). If this does not happen, most likely the problem is the operation of the DHCP client. The reasons for this can be completely different, it is easier to enter suitable values \u200b\u200bin manual mode. To do this, in the window from the first point of the article (Internet connection-›“ Properties ”-› tcp \\ IP) it is necessary to remove the marks from the points of automatic receipt and enter IP-192.168.1.101, the subnet mask-255.255.255.0, gateway-192.168.1.1.1.1.1.1 , DNS - 192.168.1.1. We save the data, rebooting if necessary.