Repair in the house is not just a small disaster, but also a bottomless pit, in which all the money goes. It is possible to save considerably if part of simple works performed by itself. So, the plaster of the walls can be completely taken over.
What are you needing tools and materials for plaster walls
Your arsenal should be:
- trowel, Kelm and construction ironing;
- level and aluminum rule;
- wide spatula;
- bucket and maclove;
- selflessness, dowel and cross screwdriver;
- drill with a "mixer" nozzle;
- plumb;
- primer and plastering mixture.
If necessary, the list can be wider.
Preparation of walls under the plaster
Before starting work, free the room from the furniture, the wires are insulate, and de-energize the sockets. Remove the old wallpaper from the walls, whitewash or paint to the base. On the brick or concrete wall, make notches up to 1 cm so that the plaster is better fixed. On the prepared surface, apply primer. 
Installation of beacons for plaster walls
If the walls are not too curves, the installation of beacons is optional. Otherwise, without them can not do. Light profile is a narrow, steel galvanized strip. The whole process consists of several stages:
- Install in the upper and lower corners into the room with an indentation from the walls of 20 cm dowels with self-draws. The distance between them should be slightly less than the length of the rule. Adjusting the number of screws of screws, set them out clearly by level. For this, the laser level is perfect.
- From top to bottom, through the hats of self-tapping screws, pull the thread or fishing line. Do the same horizontally. It will turn out two pairs of parallel straight lines.
- Under the vertical line, along its length, sketch the solution. In it, press the profile beacon, regulating the correctness of its position using the rule and level. Similarly, set horizontal lighthouses.
- Remove dowels with self-drawing.
Cooking the working mixture for plaster walls
Pour in bucket water. Drain the dry mix in it 6-8. Add the rest of the mixture, stirre and let it stand. After 5 minutes, mix again. For the first time, do not prepare the whole bag at once, better divide it in half. The solution dries quickly. 
Methods for applying plaster on the walls
Moisten the surface from the sprayer. The spatula between the lighthouses sketch on the wall ready solution with a sharp wave of hand. The sharp end of the rules from the bottom upright space, removing excess plaster. Work with zigzag movements. Under the tile, the thickness of the plaster should be at least 10 mm. 
Removal of Mayakov
Metallic lighthouses gently pull out the chisel or screwdriver, as the rust can be shot in the future. The remaining shoes are set by X-shaped movements. 
Grout posted wall
Prepare a little liquid solution. Moisten the wall. Thin layer with steel gladlict, smear the plaster on the wall. Through 36-48 hours, the walls of a polyurethane grater or shallow emery paper. 
It does not matter if the first time it turns out not perfectly smoothly. To begin with, practice on small surfaces, and then go to the entire wall.
0
1698
