The automatic swing gate was previously considered an incredible achievement, it can be said from the field of fiction. Today, the dream of many is quite real moreover With minimal cost and do it yourself. Given key moments, namely hard Compliance with the drive size and installation steps, it is worth carefully learning the system and the principle of automation.
1
The drive must be installed in the middle of the gate, if necessary, the system can be attached to the upper or lower part. Basic requirement: The second bracket must be attached to the carrying pipe structure. It is desirable that the emphasis does not contribute to the bending of the gate, but reduced the activity sharply and hard. Often the system is installed on the internal framework. Do not allow distortions.
2
By installing internal automation, prepare for numerous difficulties that occur even from experienced installers. The whole snag in a limited space between the support post and the goal loop. Critical restriction to the center of the loop should not exceed 6 cm.
3
Most pillars are made of brick or stone. The loop on such products is located in the middle, and the distance you need to the middle of the loop turns out from 15 –20 cm. In this case, the installation of automation with the internal system is impossible, therefore, you need to change something. It is necessary to initially adapt the gate to the automation or install metal running poles 10 * 10 cm. In this case, the distance you need to the middle of the loop will not exceed 5 cm.
4
If You have metal columns, then the steel bracket, which is completed with the system, it is necessary to weld to the mortgage or directly to the post. Metal welding occurs after careful reconciliation of the size and matching parts. The second bracket must be welded to the goal.
5
Installing the engine in the bracket on the column, do not forget insert Special sleeve, which comes with the main system. The connecting elements are equipped with a special backlash for improving performance and wear resistance.
6
If Brick gate racks, then it is necessary to cut a recess of about 15 cm and 25 cm in width. In this case, you will manage to install an internal automatic system for brick poles. An incision is performed using a grinder.
The automatic system is supplied complete with step-by-step instructions. Each manufacturer may provide some features of its products and offer a different installation option.
0
1013
