Installation of door loops is a process that at first glance seems quite complicated. It is really not so simple, because due to the wrong decision there may be difficulties when operating the doors in the future. In this article we will tell you in detail how to do it right.
1
Start installing a loop with doors or platbands - to solve you, most often start with the door. It is very important to pay attention to the presence of bitch: if they are in the scenes of the sings, it is better to shift a little position. Mark a pencil, putting a loop, from the upper and lower edge of the doors 20-25 cm. In order not to get confused in the loops, we mark them with the marker from the inside.
2
The chrome of the loop place exactly along the door edge, mark the screws for screws for screws, circle the loop circuit. Schillers for screws are shilling so that the screw will go smoothly in the center.
3
The loops must be recessed in the door and platband, but do not fail. To do this, in the designated circuit, swipe, then remove the top coating on the depth of the loop. Properly installed loops do not protrude for the surface of the doors. To check this, attach a ruler. If there is inaccuracies, it is better to remove and finish, otherwise there will be a big gap between the platband and the doors.
4
Spend similar manipulations with the door casing. From the top and bottom, retreat is 2-3 mm more than at similar distances on the door.
5
If there is no confidence that everything is done correctly, the loops secure on two screws, and then hang out the doors. The remaining screws can be spinning on the finished design.
We hope, thanks to our article, you will have beautiful, smooth and most importantly, neatly installed doors.
0
888
