How to roll the ceiling plinth

The main difficulties arising from the installation of the ceiling plinth are associated with fitting places of compounds of individual elements. If the alignment in direct sites does not cause special problems, then the docking of the corners requires a separate consideration of the issue.

The easiest way is to purchase ready-made angular details that have the same form and proposed as components to the plinth. The disadvantage here are additional costs.

The following solution of the problem is to cut the corners using the stub. The device has prepared slits located at an angle of 45 ° and 90 °. The plinth is installed in the tool so that its side, gluing to the ceiling, pressed to the bottom of the stub, respectively, the side attached to the wall fit. Next, cutting on metal or sharp knife is cut.

In the case when there is no such tool at hand, you can draw the scheme on the table. We carry out two parallel straight lines, place the square between them and the diagonals are diagonally. As a result, it turns out the projection of the stouch on the plane. For ease of use, it is better to further substitute the subject that replaces the side to which the plinth will be leaving.

All methods described are suitable if the corners are direct, which in practice it happens infrequently. Otherwise, the fitting of the junctions is carried out in the following order:

The plinth is applied to the angle and along its edge on the ceiling is carried out;
The same makes the same on the other side of the corner;
It turns out the point of intersection of two straight lines, which is noted on the plinth themselves;
Now the plinth falls around the side marked side, through the marked point and the edge of the plinth is performed.
We also cut a second workpiece;
We are trying on the place at the place, if necessary.

Almost ideal results can be obtained by applying a permeable saw. An example of such use of the tool, as well as the entire process of sticker ceiling plinth, is shown in the video clip.