The height and thermal insulation of the ceiling in the steam room are crucial for the quality of bath procedures. This is due to the fact that the release of steam from stones hots according to the laws of physics is on the ceiling part of the bath design. How to equip its ceiling for minimal heat losses, we will tell in this article.
1
We will assume that the upper layer of boards entering the craft space is already ready. Next, you need to follow the sequence of cooking this bath-ceiling "cake".
2
With the help of a special film, the ceiling waterproofing is performed below. This can be done with a stapler. Next lays a layer of insulation from mineral wool. Her sheets are light and comfortable in installation. Their thickness is 50 mm. Insulation is made in three layers with displacement of the joints.
3
Under the insulation is a vapor insulation layer. Usually it serves a reinforced foil. Her ends when installing, you need to thoroughly glue with foil scotch.
4
The penultimate layer of the ceiling with us is wooden rails 30x50 mm. It is attached to the final sheathing of a bath ceiling. Most often for these purposes, eurvagra from the rocks that do not contain resins are used. Reiki is stuffed with a pitch of 400 mm in a perpendicular direction relative to the location of the clapboard.
5
To pass through the ceiling of the chimney, special boxes made of fine stainless steel filled with basalt non-combustible cotton wool.
6
Part of the ceiling above the furnace should also be protected from overheating with a polished metal sheet. It will reflect warm, preventing this wood.
Observing the sequence of the above-mentioned ceiling installation operations in the steam room, you will get its reliable thermal insulation design. Good luck in work!
Share advice:"How to make a ceiling in the steam room"
0
1860
