The need to disassemble a laptop may occur for various reasons. Someone plans to clean the device from dust or produce an upgrade. Someone drives ordinary curiosity. The following instruction manual for a laptop is familiarizing. If you are not confident in your own, it is better not to disturb the integrity of the device.
1
So, if you still decided to decompose the "insides" of your laptop computer on the shelves, remember the main thing: no action when disassembling a laptop does not require an application of force. Otherwise, you do something wrong. First of all, turn off the device from the network, remove the battery and turn it upside down. Remove all the screws and remove all the covers. Pay attention to the screws that are under the battery.
2
Eating all visible devices start from a hard disk. Most often, in order to remove it, you only need to shift the opposite connection connector. Some hard drives have a special tongue for capturing and removing. It is easier to determine the offset side.
3
After hard disk, remove the drive. Usually all attachments are visible and are on the bottom of the laptop. However, there are additional screws under the keyboard. In this case, go back to it later.
4
Disconnect loops that feed the cooler of the processor and the antenna of the wireless communication modules. Antennas should be disabled in order to remove the top from the laptop. Remove the cooler of the cooling system. If your goal is to clean the computer from dust, it's time to do it now.
5
Now turn up the laptop keyboard up. It must be removed, since the remaining fastening bolts are under it. The keyboard can be attached in various ways. As a rule, protrusions and latches are used. Disconnect the keyboard loops and all the remaining.
6
To remove the top cover of the laptop, disable the device matrix connecting loops. Usually these connectors should be signed under the keyboard or under the housing panel above it. Remove the covers that close the loop and unscrew the hinge fastening bolts.
7
Next, remove the top cover and unscrew the hidden screws that you may find. After that, the device body can be separated. You can disconnect the latches using a flat screwdriver.
8
From the bottom of the housing, unscrew all the screws and disconnect the speakers. After that, you can remove the motherboard. This is usually done by offset to the side.
9
If you wish, you can disassemble the matrix lid. The attachment screws are most often hidden by rubber plugs. Remove them and unscrew the bolts. Slightly shifted in the side, unscrew the frame around the matrix. After you turn off the loop from the matrix, it can be removed.
Keep in mind, disagreeing the laptop, which was still on warranty, you automatically deprive it of warranty service.
0
3053
