The disassembly of the IMAC is carried out if it began to slow down or you need to clean the fan, the cooler case, the radiator. This process is complicated, so you should prepare in advance. New thin imacs have a screen that is attached to the housing with a disposable film. Therefore, you have to purchase the original double-sided tape, the set of stickers to collect back.
You will need:
screwdriver cross;
vacuum velcro;
torx or T8, T10 screwdriver;
mediators;
tweezers.
1
The new iMac display is located on the edge to the edges of the case. To remove the screen, you need to install two vacuum suckers on opposite edges. Then carefully pull up. This is a difficult task, so you can use the second method. Along the display faces spend the mediator. In the appears of the gaps insert mediators or ordinary plastic cards. Plastic knife We pass poorly cut places and lifting the protective glass for the upper corners.
2
Apple uses screws with an unusual knob in its devices, so you need screwdrivers T10 and T8. Unscrew the screws with which the LCD panel is mounted. Carefully raise by 30 degrees.
3
Now you will need to disconnect two loops. They are attached to the motherboard connectors that are located in the center of the case. Disconnect the microphone and chamber loops, the display loop. I will postpone the display aside.
4
Using the T10 screwdriver, unscrew the screws and remove the hard disk.
5
We disconnect the audio connector from the motherboard using a screwdriver and remove the body column.
Further actions, disassembly will depend on what you need to repair. In order not to be left, dust on the matrix and the inner part of the glass, you need to clean them before assembly.
0
3868
