A great way to save in case of breakage stiralki Indesit - to make repairs. Particularly complex process often is not, and buy spare parts for the washing machine is not too difficult. Before the work is necessary to carefully read our instructions to avoid unnecessary actions and not "commit follies".
1
Shut off the water to the car or better yet completely disconnect it from the plumbing. Also, disconnect from the mains.
2
The back cover is secured by 6 screws, it must be removed by unscrewing the screws. You also need to prepare for a folding box of screws and bolts.
3
Of the tools you will need: hex screwdriver to unscrew the screws and various flat-blade screwdriver to poddevaniya various parts, wrench and pliers to ten.
4
, Unscrew the two screws and pull it toward you to remove the top cover. It is enshrined in the grooves, it is required to draw without lifting.
5
Remove the three screws with the heads of ten, remove the upper load. Screws are screwed into the plastic tank is quite tight to unscrew them, you need to make some effort.
6
Remove the front panel. Remove the two screws at the top. Pull out tray "poroshkopriemnika". It is fixed in the grooves, and to take out the required lift and pull over. You can sway left and right. After disconnect the wire, it is necessary to remember the color of the accession.
7
To the bottom side is attached poroshkopriemniku large rubber tube which disconnect. She keeps using "rubber ear" that it is necessary to hook and pull the tube down. Take out "poroshkopriemnik" and put aside the rest of the details.
8
After removal of the rear cover can immediately extract PETN. Disconnect the wires that are attached using a very tight clamps.
9
To disassemble the car from below, it is necessary to flip it. We unscrew the shock absorbers fastening bolts on both sides. We take out plastic tanks, along with cargo and electric motor. For convenience, it is easier to work together, the springs easier to remove, lifting the talek, it is also required to open the lid of the loading hatch.
10
Remove shock absorbers. The shock absorbers are attached to the body of the tank on plastic pins, which need to slightly compress the paratasters and pull out.
11
To remove the motor, you need to unscrew two screws for ten. The engine is still dressed in two pins, cast on the body of the tank. And after these two screws are twisted, it is required to easily pry a flat screwdriver. We will remove the pipe connecting the "powder acceptor" by pressing it from the sides. After all, we remove the lower load.
We hope that our advice will be useful in this case as the repair of the washing machine Indezit.
Share advice:"How to disassemble the washing machine indesit"
0
2272
This is a permanent tank. Professionals will recommend you buy a new tank assembly.