With long-term operation of the washing machine, one of its main breakdowns is the failure of the drum bearings. When the washinger appeared at the Washing or knocking sound, if she has a shaking, then these are all obvious signs of a worn bearing. In such cases, they usually turn into a workshop, but we will try to teach you how to replace bearings yourself in a washing machine.
1
First of all, we turn off the machine from communications: water pipes, power grid, sewage. All repair robots are held at the Washinglery from behind, so they are deployed and provide free access to it. The next step of our work will be removed the back cover. Ripping the screws, remove it. Taking the cover, you need to free it from clips holding a hose, and remove to the side. Then remove the belt from the pulleys of the drum and the engine.
2
The next step is disconnecting the wires from the electrical appliances that are located on the drum. In order for the reverse assembly, the confusion does not arise in the wires, it is necessary to mark, to which terminal were connected. Disconnecting the temperature sensor requires great accuracy, the sensor tube cannot be exhibited or climbing. Because the edge of the sleeve, in which the sensor is located, and remove it into the side.
3
Weaken the nut that is attached to the TEN. Now it is necessary to remove the tank rim. Weakening the appropriate mount and remove the tank. Disconnecting the lid, remove the rubber gasket. Now you can remove the cover with the drum from the car. We unscrew the nut to which the pulley is attached to the shaft. Now we have access to bearings.
4
To disconnect the drum from the lid, we need to put it on two stands, with such a calculation so that the drum saves. We take a wooden bar and recreate the shaft of the drum from bearings. Blocks use so that the shaft thread is damaged. You need to beat hard, but neat. The drum is removed on the side, all other robots will be held on the lid. The first thing is to get a gland, picing it with scolding. To express bearings, we will need a hammer and a metal oven. We put the repairs on the bearing and light blows by choosing it from the lid. Knowing, you need to watch the bearing do not shift.
5
After removing old bearings, it is necessary to choose similar and gland. To make it easier to pressed, new bearings are lubricated with solidol. Now we take a hammer with a wooden bar and put the parting items. It is impossible to beat the hammer over the bearing, it can burst. After their establishment, we put the gland similar to the old one. Losing it with solidol, we put on the lid on the tree of the drum. Robots take carefully not to damage parts.
6
Gently put the pulley on the old place and screw the nut. So we replaced the bearings, now the car needs to be collected in the reverse order. We put back in it the drum with a lid, we wear a rubber gasket and tie rim. It is recommended to watch carefully how the laying tightly pressed. After that, tighten the scared bolt. And follow the rim to be even uniform.
After that, put the temperature sensor in its place and tighten the nut of PETN, connect the wires on a pre-prepared pattern. Having put on the pulleys of the drum and the motor belt, close the back cover, screw the screws into place. Robot assembly machines is over, now it is necessary to connect it to utilities and conduct sea trials. Thus, taking advantage of our tips on replacing the bearings, you will succeed, and your washing machine will work like new.
Share advice:"To replace the bearing on the washing machine"
I do not know, I'm afraid I do something myself to do in the washing machine, only prevention and care spending in general for stiralka, brush, land, when washing Calgon add from scale. No problems, everything works.
0
890
I do not know, I'm afraid I do something myself to do in the washing machine, only prevention and care spending in general for stiralka, brush, land, when washing Calgon add from scale. No problems, everything works.