Changing the keyboard is simple and not dusty. You just need a working device and hands, rarely disk drivers. The reason for the replacement may be a breakdown or upgrade to a more modern device. How to replace the keyboard on a computer and laptop, we will tell in this article.
1
Let's start with the installation of the most modern device - the Bluetooth keyboard. Main advantages:
lack of wires;
does not occupy USB port;
ease and ergonomic design;
connect to any Bluetooth support devices.
2
We start the installation. Open the Bluetooth application on your computer and start searching for visible devices. After a few seconds the keyboard will be detected. We connect it. Sometimes the installation software requests the introduction of code. In this case, we enter a digital combination from the screen on the keyboard and continue the installation. If the device was not detected, turn the keyboard. At the bottom you will see the "Connect Bluetooth" button - hold and repeat the installation of the device.
3
No less popular keyboard on a radio signal. In addition to the main device, it includes a small USB radio receiver. It has built-in drivers. You only have to insert a plate similar to a flash drive, to the USB port and wait for automatic settings. After a few minutes, the keyboard is ready for use. Minor minus as a Bluetooth keyboard and using a radio signal, is the presence of a battery that has the unit to be discharged. Not as fast as you think. The charge is enough for a year or more.
4
Installation already outdated, but existing on sale wired USB keyboard. Drivers for this device are built into the system. When Windows is connected, automatically recognizes the device and leads to a working condition. Connect such a keyboard to a computer simply - just insert the end of the cord into any USB port.
5
Plug, wired keyboard - the phenomenon is very rare, there was a place in 2004-2009, oriented before the release of Windows Vista and Windows 7. But there are cases when a new keyboard refused to work, and you urgently need a full-fledged computer, and the old plug savior . Then we turn off the non-working device and connect the split dust, but the live, keyboard into a special PS / 2 connector of purple. There is automatic recognition, and voila, the old woman works.
6
Now let's talk about replacing the keyboard on laptops. If there is nothing to shed anything to the digital-letter panel, do not hit it, do not put hot top, then the keyboard on the laptop will serve faithfully. Rather, the laptop will break than the keyboard. However, there are annoying exceptions. If you hit this category, do not be discouraged, you can save your portable computer. To do this, buy a special keyboard for a laptop, the corresponding model of your leptop. Go to replacement.
7
On all laptop / netbooks in the area of \u200b\u200bkeys F4, F10 and PRNTSCR have small latches that hold the panel. Armed with a needle or a thin screwdriver, carefully pith all the clamps. Now carefully disconnect the device from the loop, and attach the panel to the same place. If you are unsure in your capabilities, take the purchase and non-working laptop to the service center. So you not only save the integrity of the chip, but also their nerves, as well as money.
Taking advantage of the material from this article, you can easily replace any keyboard. If you change on a laptop, see the video attached below. There are detailed all stages of the procedure.
0
2037
