If your favorite phone has become quickly discharged, the battery charge is barely enough for the day, or even less, it's time to think about replacing the wear battery. You can make it in the service center or independently at home replace the battery on the iPhone 4S.
What tools you need to replace the battery on the iPhone 4S
By the time of replacing the old battery, it takes 30 minutes from force, it will help to avoid buying a new phone. To replace, you will need a special set of tools that can be purchased in the online store or specialized departments. If the time is still abused and the battery is still "breathing", you can order a new battery and at the same time the set of necessary screwdrivers, using the proposals of the sellers of the Chinese trading platform Aliexpress. The cost of replacement at home will be at times cheaper than payment in the service center.
Battery replacement on iPhone 4S
You can independently change the battery on my iPhone, only there is no guarantee that everything will go smoothly. Therefore, before proceeding to the most important one - disassembling the phone, we suggest learning step-by-step recommendations:
- The developer's company did not leave users any chances for a quick replacement of the battery, because it is reliably hidden inside the case. Before you begin to disassemble the phone, you must turn off the device.
- Take a thin screwdriver so that in the end of the device on the sides of the connector for charging to unscrew 2 screws. Work carefully, the screws are very small and can be easily lost, so make a white paper sheet in advance and a cover to fold spare parts.
- Very carefully try to move the back of the phone to the side. A small gap will appear.
- Now take your thumbs behind the lid and the movement "from ourselves" slightly slide it, literally a few millimeters.
- Hold on the two fingers for the protruding edge to slightly pulling up, remove the back cover of the iPhone.
- The phone carefully put on the table pre-styled with a soft towel (take a clean kitchen, fold into several layers). These actions are needed in order not to damage the screen and protect it from scratches.
- Now you need to disconnect the battery. To do this, unscrew with the cruciform tool the retainer located on the device board.
- Next, you need to disconnect the connector in this way: Carefully pull up towards the battery. Under the lock is fastener (black), try not to damage it, work as careful.
- Now you can try to get the battery, but it's not just just, because it is glued to the housing itself. To disconnect it, you need to pull the retainer (this is a plastic tongue), at the same time, on the other hand, pry a battery with a special plastic tool with a flat tip.
- Some masters to quickly remove the old battery include hair dryer, directing the stream of warm air to the back of the phone.
- After the efforts made, you will be able to remove the old battery.
- Glue completely from the inside of the case do not remove, the new battery will "sit".
Installing a new battery on iPhone 4S
Do not hurry to immediately put a new battery, first it is necessary to clean the inside of the phone from the contamination with a dry cotton wand. Try to do everything slowly and carefully to damage anything.
Repeat your actions in the reverse order - insert a new battery, fix, connect the connector and then screw the 2 rear cover screws. Do not worry, screws are absolutely identical and impossible to confuse them.
You can now enable the phone and check the operation of the device.
0
650
