Washing machines with display are very comfortable. With the help of the screen, you can define the remaining time of washing and learn about breakage. SAMSUNG washing machines are cheap and popular. If the work of the household device is stopped, this does not mean that it is necessary to call the wizard. Using the set of numbers and letters, which are displayed on the machine display, you can learn about the cause of the problem.
1
1e - an error or breakage of the water level sensor. This happens as a result of damage to the tube or when it is clogged. Sometimes the sensor itself is defective, and the tube is intended. Also possible failure management system.
2
3E - motor tach generator error. At the same time, various numbers can stand near the letter, indicating a specific problem:
3E1. A lot of linen in the drum that does not allow the engine to work correctly. In addition, there may be damage to the contacts in the motor, as well as the half of the taogenerator.
3E2. The code indicates an intermittent signal from the tachogenerator. Can deduct contacts.
3E3. Incorrect signals that taucan gives. Most likely, the problem is in the work of the sensor itself.
3E4. Breakdown of contacts. The tanet has failed.
3
Error with 4e characters is lit in the event of interruptions in water supply. Most often there is a weak water pressure in the system or damage to the suction hose. Sometimes the water supply tube is located in a bent position, which prevents a good pressure. If the tube is not bent, and the water pressure in the tap is good, then the filter was clogged, which is set at the beginning of the water supply system. The code 4e may appear in the case of improper selection of temperature when washing delicate tissues (above 50 ° C).
4
5e - error during water drainage. The occurrence of this code is observed if the drain hose is scored or foreign objects are present in the water removal path. Or in pipes for draining are coins, buttons, clips. Sometimes 5e glows when the contact breakdown and as a result of water freezing in winter time. This code appears due to the impairment of the impeller of the pump.
5
8E - engine breakdown.
6
9E and UC - feed cord error. Most likely, the wire or voltage in the network differs significantly from the norm.
7
Ae and B errors may arise due to damage to the control panel. This is possible as a result of a short circuit, which provoked the heating of the display and buttons. Relay malfunction. Code DE testifies to moves with the door. It happens due to the scene between the hatch and the fabric machine. Sometimes this error is highlighted due to the drying of the sealing gum on the door.
8
Not and Te - breakdown or heater error. This code indicates the overheating of the device due to breakage of the temperature control sensor. The actual heating does not correspond to the valid temperature value.
9
Le - water leakage. Damaged drum or air hose. Bad attached tank or sealing washers. Excessive amount of foam provokes fluid leak through a hole for detergent.
10
Its and UE is a violation of the drying mode (if there is such a function in the device).
Most often, the errors that are displayed on the display indicate an improper operation of the instrument, and not about the real breakage. Therefore, before calling the master, you need to carefully inspect the device.
0
2471
