Experienced drivers argue that the installation of an additional stop signal facilitates travel during intensive traffic on the motorway. The cash costs for the installation are minimal, and the cost of repair due to an accident is incommensurable. But additional signals will warn drivers in a timely manner about holding a maneuver or braking.
1
Prepare to perform tuning rear lights of your machine the necessary tools: Stop signal, knife, thick isolent, screwdriver set, wiring. Decide in advance with the location of the stop signal, because its main purpose is to ensure safety on the road.
2
The varieties of the rear stop signals are classified according to the method of fastening to the car. Traditional fastening sites: rear bumper, car spoiler, inside the passenger compartment on the rear shelf, behind the glass. After selecting the desired fastening format, it is necessary to select the size of the additional stop signal, especially it is important if the mount is to spoilee or to the rear glass.
4
The next important step is to calculate the capabilities of the car wiring. Powerful modern electrical equipment can create problems with a generator and battery in old auto domestic production. Additional stop signals will be able to install, and the operation of the machine's electrical system will violate, as a result of which the battery will quickly fail. Pick up additional equipment, given the possibilities of the car.
5
With the knowledge of the basic principles of the operation of the electrkets, the installation of the rear light will not cause difficulties. Fix the device inside the passenger compartment on the rear shelf. Plus Wire Contact Connect with wires placed under the rear sofa, rear stop lamp wires. Minus wire wrapping through the trim on the car body. This method is the fastest and economical.
6
If the shelf in the cabin is not free, then the third brake can be mounted on the bumper. With this type of fastening positive leads connect to the rear regular stops, negative - any metal part of the bumper attachment. Note that this type of fastening is more suitable high vehicles, such as jeeps, microbuses. On normal cars on the installed accessory will accumulate dust, dirt, and it will not look very nice.
7
On the rear spoiler most complicated way stoplight fastening. We spoiler hollow structure, and wiring necessary to reach inside. Otherwise, when the spoiler is not void, it is necessary to fix the wire brackets for the bottom.
8
Properly insulate all places wiring connections. Positive leads must not come into contact with the casing of the machine, choose a robust, thick electrical tape. In the event of a short circuit due to contact exposed metal positive and negative wires or metal portions of the car body can break down the entire electrical system of the car and you have to costly repairs.
Use very high quality wiring for an additional stoplight. Cross sections of cables and wires similar to regular vehicles should be the same. Do not forget to disconnect the battery before starting work, disconnect the positive lead.
0
1901
