Music for many is an integral part of life, and drivers are no exception. But only from the car radio and the factory columns of good sound does not have to wait. Sometimes it is necessary to tinker and connect new columns to the radio.
To connect you will need:
Radio;
Columns;
Acoustic cable;
Corrugation;
Insulating material;
Drill;
Rings-gaskets;
Tester.
1
Decide on the column settings, well, if they are provided in the car - usually the front speakers are located along the edges of the dashboard, or in the doors of the car. If there are no full-time columns, you can install them yourself, for example, in the door of the machine. The second pair of speakers is most often located on the rear shelf of the car.
2
If no holes for wiring are provided in the doors, then they must be drilled. It is impossible to stretch the wires through the metal or plastic just like that, so install special rings of the gasket, secure them hard on the inside. To the speakers located in the rear of the car, the cable is easiest to spend along the edges of the car. Where the acoustic cable passes under the rugs, it can be easily damaged, so it is best to climb it to a general wiring, even if for this you will be partially different to disassemble the car's trim and dashboard.
3
Wires thoroughly insulate, pull the corrugation and immediately wash out which wire to which column - left or right, front or rear - goes. This will facilitate you connect the speakers at the final stage. With the help of a wire, or dismissing the door trim, tighten the wire inside. Wiring for the rear speakers swipe oneboard car. Secure the wires using plastic clips, for reliability areas that go on the floor can be tightened into the corrugation for the electrocabilities.
4
If you use all the wires of the same color, you do not forget to mark and minus when marking. After the wires are marked and divorced by car, check them on the absence of short circuit. If everything is in order, you can connect them to the connector and install the automagnetization into place. Remember that all manipulations with the connection of the wiring must only be performed when the battery is turned off!
5
Then check the speakers on the resistance, it should be no higher than 4 Ohm. If the tester shows from 3 to 4 ohms, then set the speakers in the location designed for them and connect to the wiring. Be careful - the opera terminals should not come into contact with metal parts of the car. When everything is connected, check the audio system.
6
If you do not understand the electrician at all and you are afraid to intimidate something and, thus, spoil the equipment, then you better rely on professionals and contact any firm engaged in installing autocustics.
From any audio system, you can get a good sound if you approach it with the mind. At the same time, do not overestimate your strength, otherwise you have every chance to get in the end completely not the result that was calculated, but even to spoil the car audio system at all.
0
14269
