Modern cars have more maximum equipment with appliances compared to old. For example, there is an econometer that is intended to determine the discharge within the collector and saving fuel by adjusting the speed of movement.
1
To install it, you must select a place on the car instrument panel in such a way that the steering wheel, controls did not clutter the visibility of the device. In older models, you need to break the integrity of the panel and make a hole yourself.
2
To do this, remove and disassemble the control panel, according to the instructions that have each car. The econometer is installed on a free place or in place of another device. Pre-try the location of the intended installation and the instrument housing. If the size of the econometer is not suitable in size, you need to make an adjustment. After refinement, the device is installed using self-tapping screws.
3
To establish a torpedo under the steering column, you can use a piece of fastening for the preparation of the bracket. The econometer with all other devices is checked by a voltmeter and fixes on the panel.
4
Connect an econometer. Instead of drain plug plug, a M-shaped fitting is screwed down, a fitting with a copper tube and a hose is satisfied. You need to use a thick rubber tube of a vacuum corrector, which is carried out to the engine compartment.
5
To connect an econometer, you can not use the plug, and drill a separate place and screw the carbureter fitting, hose.
The installed econometer will show the degree of discharge of the intake manifold and will allow you to control fuel consumption.
0
1903
