During the operation of the car, it may be necessary to replace not one audio system. The reasons to replace the car radio are different: a malfunction of the old audio system, someone wants to enjoy in their car with a better sound, the fashion change annually, the improved models of the car radio. Not in every car installed a radio tape recorder, and bought new acoustics, it is not necessary to contact the specialists. Connect the car is not difficult, the main thing is to correctly determine the functions of all plugs and wires.
1
It is very easy to install a car machine with a tape and a screwdriver set. You need to trim the wires from the electrical wiring or the plug of the radio. Insulating tape connect wires, taking into account the color marking. This method of installation has a number of shortcomings. The tape is not a very safe clamp, so a short circuit may occur in the cold, and it will also look unattractive. Avoid short circuit will allow clamping terminals or a shrink tube.
2
If all the automagnet connectors are fully suitable for the car, it is an excellent option for its mounting to the panel. The level of complexity during the installation will depend on whether all the wires are listed to the place where the device will be installed. If all modifications are present, you will only need to connect it to all connectors to install the radio. However, the connectors may not be approached, even if all the necessary wires are displayed to the location of the radio tape recorder. This problem can be easily solved with special adapters.
3
ISO marking is an international standard installed for the manufacture of car and automotive wiring. If the connectors do not comply with these standards, which is often found on car outdated brands, they should be replaced with new ones. Before you start connecting the radio, you must disconnect a positive terminal from the battery. You should disconnect one wire from the old connector and connect to a new one. Wires need to be connected well, it is better to disappear, which will avoid unnecessary noise. Isolate the places of compounds with a tape, but it is better to use heat shrinking cambricks that decrease in the heating process. Complete the replacement of connectors may inappropriate color marking. In this case, you should use the tester.
4
The most difficult to connect the car radio, if the wires are not laid. It is necessary to purchase wires with a cross section of at least 4 mm². For acoustics, special wires are needed providing good sound. On the rear panel, the radio has a marking that allows not to be mistaken when the wires are connected. Yellow power "Pole" should be connected to a positive battery terminal. Then you need to connect the masses "masses" marked with black. The "masses" wire is attached on the body using a screw. Red wire (second "Pole") should be connected to the ignition lock. Wires to connect to the speakers. At the last stage, the antenna is connected. If the antenna is passive, it is worth inserting the plug into the corresponding socket. To connect the active antenna, you will need an optional power conducted to contact the radio (REM, AMP, ANT).
Installation of the car radio independently allows you to get practical skills that will not be superfluous for the motorist.
0
10996
