It is not enough to choose a good speakers in the car, you must still be able to cut them correctly. The main thing for the flawless sound of high-quality acoustics is good noise insulation in the car. Where to cut the columns, choose only car enthusiast: in the door of the car or in the rear shelf. Some drivers do not like when the music sounds from the back. But not everyone thinks. We use the advice of specialists and find out how to cut the columns correctly:
1
To embed the speakers to the front doors, you need to: install the header, make the podiums for the speakers, place a subwoofer, stretch all the wiring.
2
With wires will have to tinker. In those housing openings, where veins pass, you need to insert rubber or plastic tubes so that there is no closure, i.e. did not break through the mass. And we put the plus wire in the flask, as it is located near the car battery, the distance between the battery and this flask should not be less than 25 cm.
3
After that, we connect the wires to the head devices and the soldering iron we sold down the power veins to the wiring of the radio. The wire that goes on the plus, skip through the fuse (fork), connect the block with multimedia. Then to the outputs of the multimedia device we attach inter-block wires. Install the head unit and power wires that go to the amplifier by crimping the terminals.
4
The noise insulation of the door is best to smoke: STP, then sound insulation, the next layer - STP, and then the substrate.
5
It remains to make a podium for speakers, for this you need to take a paneur (thickness 12 mm) and cut the blank of the desired configuration. It is safe to attach to the door and apply a mounting mixture. After that, we give the right form of the product, we glue with fiberglass and epoxy, let me die. And at the end, everything is creative, put the column in the podium.
6
If you decide to cut the columns in the rear doors, then everything is performed in the same sequence as described above. And to embed the speakers in the rear shelf, you need to cut holes of the required diameter, make the podium and noise insulation. Put the subwoofer first in the box, then in the rear trunk. Connect wires.
For long-distance trips to music lovers, the advice of experienced masters will help properly build the speakers with their own hands. And not only you, but also your fellow travelers will be able to enjoy the excellent sound of your favorite music.
0
3240
