Creak wooden floors what to do

The tree is a popular material that has since been used as an outdoor coating. And today the wooden floor is considered a sign of prosperity. Although the wood is a durable material, over time, such a floor will also deteriorate, cracks occur on it, the areas of rotting under the influence of moisture, it begins to creak. But despite this, the situation can be corrected.

1
Causes of violin

Any problem, including the creaking of the floor, can be eliminated if you know the reasons for its appearance. This sound occurs when some composite elements rub together.

Provoke the creak such phenomena:

The friction of the tree about fasteners, which leaned out of his nest, whether it is a nail or screw;
Incorrectly fixed floor plinth;
Lag movement;
Movement and uneven drying of boards, for example, in the case of a bathroom;
Cracks in the planks;
It is not provided for the clearance of the wall;
Peeling the wooden floor from the base;
Layout of the castle on the parquet - groove or crest;
Installation of raw boards;
Laminding fasteners.

2
Chucking Kliniev

This technique is prescribed when the boards are poorly attached to the lags and rub each other. To prevent this friction, it is customary to hammer the wedges into the space formed between the board and the beam. Wedges are driven, withstanding a step of 15-20 centimeters, while they should not rise above the floor level. If it is impossible to get to the bottom of the floor, the boards are fixed from above. In addition, it is possible to eliminate unpleasant sounds by swelling in the slit of a special substance, how the graphite powder or talc appears.

3
Filling foam

Mounting foam is an excellent option for mini-repairs. After the spinning of the space under the floor, the foam will expand, and as a result, the flooring becomes rigidity. But it is worth considering that the method is not very effective because the foam is capable of collapsed over time. She remembered, so the creak resumes again.

4
Metal anchor

If the base of the floor is concrete, the metal anchor is used to get rid of the tree of the tree. After drilling a hole, a metal shell is installed there, an anchor stud is screwed. The methodology is inherent in great efficacy, but also the cost of such work is also noted.

5
Laying plywood

With sounds emanating from a flat wooden floor, it is recommended to choose the option with stacking plywood, which is attached using adhesive composition. As a rule, sheets choose, the thickness of which is 12 mm. You need to lay them at an angle to the plastered boards. However, in this case, there is no guarantee that the sound of a creaking floor will not resume subsequently.

6
Broach self-based

If the creak is formed when in contact with the lag and boards, it is worth making your choice in favor of this method as a broach by self-draws. The hardest moment in this work is to find the very defective flooring. It is also recommended to pay attention to that, if there are no communications. The repair process for the elimination of sounds is reduced to drilling in defective places of holes that have a thickness of 2 mm, twisting through a 2-3 board of self-tapping screws into the lag or beam and shtclotation of the pre-sealing top. Remember that the screw screw is to be dragging in the wood.

7
Floor tightening

This method, which is also called a bulkhead, is a time-consuming procedure, which is to verify the state of the lag and boards using the bust. If some defect is detected, it must be corrected. In addition, within this method, all nails are customary to replace on the self-tapping screw, as they do not have such a lack of nails, as possible creaking sounds in places where they are connected to the wood. Especially quickly, nails are loosened in places where there are a lot of stress on the lags. Thus, when the wooden floor device is better to initially use the self-tapping screw or in the absence of such long screws.