How to start the car without a key

With each unpleasant story with a loss or breakdown of keys from the car. This situation can happen in the city, in the forest, in the country, on vacation near the reservoir. The key recovery will take a long time, as you have to change all the locks of the machine, including the castle of the steering wheel mechanism. Especially since the service is still needed. Therefore, you have to start the car without keys.

To begin, it is necessary to dismantle the protective casing under the steering wheel to gently reach the ignition system and disconnect them. The main thing is to determine where and which wire is located.

You need to start with the definition of "land". Often ground wire has a green or black color, sometimes it can be yellow with a green stripe. If, when you closer to the selected wire on the car body using the tester, the arrow does not deviate from zero, then this ground wire. The end of the wire must be inlated to avoid damage during accidental contact with other wires.

Power wires can be determined by using the color marking or measuring device. The power wire has yellow or red. Properly connect the negative black probe tester with the "Earth", and a positive red probe - alternately with all the wires. The tester arrow will donate from zero when the probe with the power watches. All found power wires should be insulated.

The next step is to determine the wire of the feeding starter. Handbrake must be translated into a neutral position. All unidentified wires in turn are connected to the feed wires that were determined earlier. One of the wires will lead the machine starter. For convenience, it can be labeled with a tape of another color.

The remaining wires are responsible for the nutrition of the car and all devices. These wires need to be combined with wires and twist so that they do not break down with the further movement of the machine. Finally, you need to close the wire that feeds the starter on this connection. After the car started, the starter wire should be disconnected and isolate.

After you started the car without a key, the car can go. In order to drown out the engine of the machine, you must disconnect the power wires with the wires feeding voltage.