The clutch is an important element in the mechanism of the car movement. Its main tasks: to transfer the moment of movement from the engine to the wheels, a short-term break of this transmission during the pressed clutch pedal. The level of car depends on the quality of its work, fuel consumption.
1
If the machine is new, it is especially important to pay attention to the state of the gearbox. The clutch drive must be checked by driving the first 2000 km. Adjust it if necessary.
2
With the engine running, lick the clutch, listen, how the engine noise changes. Only at the same time the clutch position can be determined by the correctness of its disconnection. The appearance of new unusual sounds means the presence of faults in the shutdown bearing. The clutch shutdown bearing must be checked every 15,000 km of rumor.
3
If you are an inexperienced driver, we still understand the principle of the functioning of the car's clutch, no matter how difficult it seems. It is necessary to know its purpose and device, the mechanism of clutch and disconnect the engine and the gearbox, how the engine is protected from sudden loads.
4
To turn on the clutch release the pedal. At the same time, the springs begin to press the pressure disc. The drive disk is pressed to the clutch disk, and that is already to the flywheel. The whole system, both disks and flywheel move simultaneously, the torque is transmitted to the engine from the engine due to the work of the friction force, through the details of the transmission.
5
To turn off the clutch, click on the extreme left pedal. Its full course is about 140 mm. With proper adjustment, the free passage of the pedal is not more than 35 mm. To start motion, you must turn on the clutch. The whole process consists of several stages. Initially, the transfer is included, the clutch pedal is pressed.
6
The drive system begins to operate. The release bearing presses the release springs, the surface of the pressure disk is 1.4-1.7 mm from the clutch disk. The disc is released, and although the engine works, it does not transmit a torque, the gear shaft finishes rotation. Now the clutch is turned off and you can switch the transmissions, you can brake.
7
Now the clutch pedal is slowly released. The impact of return springs it will return to the original position. The clutch mechanism is activated, the pressure disk slowly presses the slave disk to the flywheel.
8
The clutch is the most loaded system of the machine, so I begin to have problems switching speeds at a certain time. Need to immediately, not postponing, solve this problem. To clarify the clutch wear, you need to explore the slave disk. If he is spoiled, then replace.
Turn off the clutch, that is, press the pedal, you need to make the most smoothly, do not let go sharply. In general, all three stages are performed without jerks, gradually. Otherwise, the car is twitching, and the engine can stumble. If the pedal has too free stroke, the clutch turns off not completely, it is necessary to adjust it. Check the brake fluid level in the system at least once a month, pressing the clutch pedal is useless in the absence of fluid.
0
2849
