How to set rails in the kitchen

Installation of various railings for the kitchen is to study the design, preparation of holes and assembling the parts of the kit.

To work, you will need:

Drill, drill winner;
Building level;
Hammer, screwdriver;
Key hex;
Dowel and screws.

It is useful to have a metalwork for metal, if you need to shorten the tubes.

Railings on racks are pre-collected. Using the hexagon, in the housing of the holders "naked" two coils. The rod is inserted into the holes of the racks, given a number of moments:

Screws are sent down;
Hooks can dress during the road mounting;
The edges of the tubes will be closed with plugs;
The joints of the composite rods and angular elements are located inside the racks;
The number of holders is two on the pattern meter or more with a strong load.

After the distribution of racks on the tube, locking screws are tightened.

The consistency of the horizontal railing:

The product is applied to the wall in a place convenient for the placement of the kitchen utensils: 5-10 cm from suspended cabinets and 45-50 cm from the tabletop.
Pencil marks the attachment point of the extreme holder.
Hole dries A diameter is slightly less than a dowel and 10 mm deeper than its length.
Dust blows out, and the plastic plug is clogged with the surface.
The reference sleeve is screwed screw, the holder dresses it.
In terms of level, the second end of the railing is set, the label is set near the rack.
The following hole is performed, the sleeve is fixed.
Holders are installed on their places and are delayed by retainers.
End plugs are harvested, usually consisting of a cap, couplings and connecting screws.
The ends of the tubes are closed with decorative plugs, carefully having a rubber hammer or through a wooden laying.

The process is repeated for the rest of the rod.

Suspended rails are placed on the ceiling or on the bottom surface of the cabinets. They are installed on the same principle, but special attention is paid to the strength of the attachment - metal anchors and bolts are used. Vertical rails are with a pipe-holder, which is mounted between two limiting planes: ceiling and bar counter, table and shelf. Some crossbars have a sliding design and mounted by versuses without the use of fasteners or glue.

When mounting the kitchen rails of the overhead type (without racks), horizontal or vertical markup is also performed, the holes are made and the mounting brackets are screwed. Then the planks are put on the locksters and just snap.

The use of rails in the decoration of the kitchen allows you to solve the problem of placing the set of accessories and rationally use the space. They are inexpensive and easily installed on their own.