How to install toosol heater on vaz

Start the engine of the car VAZ into severe frosts - it is often problematic. To make it easier, this work will help the anti-tosol preheater (it is often referred to as the "boiler"). When installing the heater, it will be necessary for the electrical, imported branded clamps, tosol collection capacity and reinforced cooling system hoses, as well as a control panel with a timer.

Most importantly, remember that when installing the boiler, we are dealing with flammable and toxic substances, so it is important not to forget the safety regulations. We drag the toosol into the prepared capacity. If there is great experience, you can install a boiler without merging Tosol.

Electroproma of domestic production protects the heating element from overheating. For its attachment, choose a place lower either under the hood, or behind the bumper, the height is harmful to the pump.

From the heater stove, remove the hose going to the salon. We attach a tee to this hose, and from the tee we make a branch for pump input. We connect the heater input hose and the pump output. It's not scary if they are next to each other. We had free two more entrances on the tee.

We cut the upper radiator pipe. Then we connect it to the tee. Similarly, connect the output end of the toosol heater. Compounds of hoses necessarily fasten the clamps. Thoroughly wrap the gaps and joint sealants.

We establish a timer, which includes the heating element at a certain time so that the toosol does not overheat. We pour a new toosol to the desired level.

Install the control panel of the heater on the instrument panel, or more convenient, fixing with screws. Through the available holes in the front panel, we lay the wires from the control panel to the boiler. Wire contacts set the pads in the slot on the heater.

We supply the power supply of the heater to the sockets 1, 2, 3 and 4 of the KS4 pads according to the electric compound scheme of the VAZ car. It is important to disconnect the power of the heater when the control panel is connected or disconnect. Connect the wires to the battery terminals. Turn the tap of the heater to the right until it stops. Run the engine to check all installed hoses for leaks.

The toosol heater is set, it remains to wait for frosts to test the installed system. Note that the hoses must be changed from time to time, since the fluid is quickly corrosive.