The safety of people in the car during its movement is largely determined by the quality of illumination of the carriageway and the drive angle. Both of these factors are significantly reduced when dust, dirt and other road garbage trawls come to the windshield. To get rid of it, in every car there is a special system consisting of a washer tank, nozzles splashing water on glass and janitors.
1
It happens that the windshield cleaning system gives a failure, leading to partial or complete failure. Move on a car with such a breakdown is impossible. To detect and eliminate the fault, you can contact a specialized maintenance station, and you can try to do it yourself, while saving a decent amount of money. The bulk of the faults is somehow connected with the washer tank. That is why the work on the identification of the breakdown should be started with its removal and inspection. To conduct you, you will need the following tool:
passatia;
screwdriver;
horn key.
2
Install the car on a flat pad, tighten the handbrake and open the hood. If the tank in your car is closed with protective overlays - first dismantle them, then disconnect the wires from the fluid level sensor and the washer motor. Using Passatias or a screwdriver, loosen the clamps fixing the nozzles, bringing water to the nozzles. Submold under the car the container for collecting the washing fluid and disconnect them. Unscrew the screws that the tank housing is attached to the car body and, pulling up, gently get it out.
3
In some cars, the washer tank is hidden under the wing, which somewinds it somewinds somewinds. To get access to it, you can remove the car wing, but if you want to facilitate this task - try to get to the tank through the wheel arch. If you do not have the ability to use the lift - use the jack. Install it from the side of the tank and lift the car. Remove the wheel, then dismantle the plastic liner. Disconnect all the wires and nozzles from the tank, then twist the locking nuts. Pull the tank down and gently get it out of the wing of the car.
4
Removing the tank, proceed to its detailed inspection. Depending on the detected breakage, you can go in two ways: try to repair the old one or replace it with a new one. The tank setting is made in the reverse order. After connecting all wires and nozzles, pour a new liquid to clean the windows and check the system in action.
Removing the washer tank - the lesson is not complicated, but making it yourself, you can better explore the device of your car and save on a trip to the car service.
0
2861
