How to make a hive of plywood

The breeding of the bees and the possible increase in their number invariably require worthy "housing conditions" for small drunks. Experienced beekeepers prefer to shut apart with their own hands. And to significantly save allows you made by the plywood yourself. Recently, two-wall houses from plywood with an interstitial insulation of foams are especially popular.

For the manufacture you will need wooden bars, waterproof plywood, foam 20 mm, nails. Pre-draw the drawing with precise size. We prepare the framework of a certain size from wooden bars, which will be afraid of plywood.

Cut the resulting frame to the front, rear and side walls from plywood sheets. Observe the angles of 90 degrees. All walls attach perfectly to the bars, without gaps. Must get a box.

2 frames are fixed in the resulting drawer. And insulation in the form of foaming (20 milieters) is inserted into the housing, the hole for the pilot is cut.

The frames are hung and the ceiling of the hive is attached, after which the bee house is covered with a roof.

The resulting hive of plywood is durable, light, and, it means, practical and makes it possible to easily transport bees on the medical unit. The only weak point of such a hive is the disadvantage of plywood, which is rapidly stratified under the influence of rains and winds. However, the problem can be solved painting. This will increase the service life of up to 20 years!