To complete the landscape design, flower beds and flower beds are used. If the seats on the plot are not enough to arrange a full-fledged flower garden, but I really want to enjoy the blooming plants, you can make a flower leaf from a car tire.
1
There are several options for setting flower beds from tires:
vasons;
animals;
multiplication heroes.
2
If you do not have experience, and before that you never worked with tires, try making the easiest flower garden in the form of a vase with curly edges. To do this, wash the tire of the appropriate size and let it dry. With the help of chalk, draw the petals, it is recommended that the length of the leaflet is not more than 12 cm, otherwise at the end of the work it will be difficult to give the product the desired form. For cutting, you can use a very sharp knife or jigsaw. Walk the knife along the outlined lines and remove the tire inside out. For this you will have to work hard, as the domestic tires are very tough.
3
Now wash rubber with soap and treat the solvent. Only after that you can proceed to coloring color. Keep in mind, it is better to use winter tires for foreign production for the manufacture of flower beds. It is plastic enough, so it is perfectly cut and turned out. Place the drainage layer on the bottom of the flower bed and only then fill in fertile soil.
4
Cascades, consisting of several tiers of rubber, look very harmoniously. For the manufacture of such a flower beds, wash the tires of different sizes and cut them in half. Should get a shallow rings. Place the largest tire and fill it with soil. Top on the tire to put the ring of a smaller diameter, the smallest bus on it. Try to place the tires are not in the center of each other, but in the very edge of rubber. In such flower beds it is best to plant curly plants.
5
Looks pretty Parrot bed of the tire. Belly Bird will serve as the capacity to fill the earth and growing flowers. To produce such a flower bed by means of a jigsaw or a saw to cut the top half of the tire. On the other hand, do the same. For these rings, we will suspend the parrot. Now you need to cut the tail and snout birds. From a long piece that remained after cutting rings do tail. With the help of the jigsaw give it figured form. From the top of the tire make a muzzle. Color the parrot, draw eyes and beak. Try to color the birds contrasted with the color of plants. Fill the flower bed underground and hang over the tree rings.
If you do not want to cut anything or you do not have a jigsaw, fabricate a bed-frog. To do this you need three of the same size tires and two empty cans of paint. Paint all the tires in green. Two tires put the butt. The third rubber lay in the center of the lower contact of two tires. The upper lid - is the head of the frog. Remaining liquid nails paste cans of paint to the upper rail. Paint cans of black paint and white paint pupils. Before installing the upper bus tires need to fill the lower primer. Lest the land spilled to the lower part of the upper beds attach plywood.
0
1832
