Most often, large residential buildings are heated using a steam heating system or a large oven built in its center. But what to do if you want to warm a small country house, a garage or any other household room of small sizes? The answer is simple - to use the bourgear stove, which can be done independently without much difficulty.
1
To carry out work on the construction of the bourgeitors you will need:
welding machine;
steel corners;
bulgarian with a disk for cutting metal;
hammer and chisel;
protective glasses and gloves.
2
The easiest view of the burzhuyki, which can be made independently, is a furnace of steel barrel. The first thing to be done is to make sure that the barrel is not rotten and its walls are quite thick. Checking it, securely weld the cover to the base throughout the perimeter. Then shift a rectangular hole in her day - it will be a firebox. With the help of loops, welding or bolts, fasten the door, which can be used a previously cut piece of metal. From the opposite side, do the chimney round hole. For its manufacture, use the metal pipe, with a diameter of 7-8 centimeters. The stability of the design can be given using a metal frame from the reinforcement or simply putting onto the legs.
3
A more complex design is made of a gas cylinder. At first it is necessary to find an empty cylinder from under the propane. Having done this, with the help of the Bulgarian cut its upper part - the one where the crane is. If you take care in advance and purchased the doors for imagined and the fireboxes - attach them to the bottom of the balloon and circle the marker. Cut holes need inside the drawn figures - retreating from the edge of 1-1.5 centimeters. The next step is the welding of the metal lattice, distinguishing the inner space of the cylinder on the furnace and the ash bar. After that, you can start making the frame for the door. For its manufacture, it is best for steel corners with a thickness of at least 3 millimeters. When the design is ready, drill the holes for fastening the loops of the door and breed it to the cylinder. Screw the door with bolts. Where the crane was used to be located, which you were dismantled at the very beginning, weld the chimney. If you give him a curved or spiral form - the efficiency of your oven will increase significantly. At the end of the process to the finished bourgear, brew legs. Now it can be used.
4
Another popular species of bourgeoque of its own manufacture are ovens working on spent oil. Of course, the residential premises are not recommended by them, but in the garage such a furnace will warm you very quickly. For its manufacture you will need a thick sheet metal and several steel pipes of various diameters. A thicker pipe (preferably with a diameter of about 40 centimeters) put on a metal sheet and blast the chalk. Carefully cut the resulting circle with a grinder or gas cutter. Make 4 such blanks. From the pipe cut 2 pieces, a height of 15 and 10 centimeters. To their top and bottom breed metal circles cut earlier. In a thinner tube, a diameter of 6-7 and a height of 35 centimeters, drill 25-30 holes, evenly distributing them all over the area. In the center of the lower, higher tank, do the hole of the corresponding diameter. In the upper tank, it is also necessary to make the same hole, only it should be shifted to the left from the center. Using a pipe with holes, connect the tanks among themselves and reliably folk all the joints. To give the design greater reliability, the tanks can be combined with a support beam. On the right side of the top tank cover, do the holes to attach the chimney. In the lid of the bottom tank cut the circle to supply fuel. The last step is to attach legs. For greater stability evenly position them around the perimeter of the lower tank. It is recommended to do 6-8 supports.
As you can see, make a burgundy with your own hands is not so difficult. A properly manufactured furnace will help you not only warm the small room, but also enjoy the pleasant crackling of the light in the cold winter time.
0
7901
