The water supply conducted significantly increases the comfort of living in a country house. Work on its installation is not very simple, but they have nothing like that a person armed with knowledge and a necessary tool could do. As a rule, the water supply is paired at the construction stage of a residential building, but it can also be held in a long-built house. In any case, the installation works can be started only after you have a resolution agreed with the architecture department and urban planning department. The water pipe can take its beginning from the central highway, well or well.
1
To perform work, you will need:
correctly decorated and consistent permission to install the water supply;
shovel for trenche;
water supply pump;
pipes, couplings and cranes;
soldering iron (for connecting PVC pipes) or wrench (for connecting metal or copper pipes);
heat insulation materials.
2
If your water supply will be powered from the well before starting it to build it, make water analysis. If it meets the sanitary standards and requirements - you can start work. It should also be remembered that special permits are required to install such a water supply, which will greatly facilitate and speed up the fulfillment of the task. Special attention is paid to the selection of the water pump. Some of the best are automatic pumps, for example, Pedrollo JSWM, Komfort Aujet1200 or ELPUMPS JPV. However, when choosing such a model, remember that you will not have the ability to adjust the water pressure and pressure, that is, your pump will always work with the same power no matter how many cranes are included in the house.
3
After the well is ready, proceed to the ruin of trenches in which the pipes will be laid. The depth of them should exceed the level of ground freezing and be about 0.8-1.1 meters. Cutting pipe Close with thermal insulation material and pour out the soil. One end of the pipe is placed in a well at about 40-60 centimeters from his day and install on its filter. To connect plastic pipes, use a special soldering iron, for steel or copper pipes - couplings and wrench. On the length of the water pipeline, make several viewing wells, which, if necessary, will help you clean the resulting blockage or estimate the condition of pipes after long-term operation. Inside the house or special room, install a pump that will swing water from the well.
4
If the water source on your site will be a well, then first you will have to get permission for it drilling. After you do this - call the team of specialists for land work. As in the case of a well, not the last place occupies the choice of the right pump. For the well, submersible models are perfectly suitable, which can freely swing water even with a depth of 6-7 meters - Pedrollo 4blockm, Grundfos SQ 3-65, "Aquarius" BCPEU-05-63U and others. When the well is ready, proceed to laying pipes. If water flowing out of the crane is muddy or with some tint - install a special cleaning filter.
5
If there is a central water system near your home, then connect the house to it is not very difficult. To do this, you need to get the necessary permission, make a scheme and conclude an agreement with the relevant organization. A few days later, a brigade of workers will come to you, which will hold all the work, and you will remain just paid for them. After the installation is completed, the water meters will remain to establish a water meter and conclude an agreement with water voltage. Then you can enjoy all the charms of central water supply in your home.
As can be seen, the installation of the water supply can be performed or to trust their specialized organization itself, but in any case, before the start of its use, be sure to check the system for performance and absence of leaks.
1
1856
