How to cut a tree

How to cut a tree

In order for the site to look neglected, it is necessary to apply a lot of effort: we form a fence, planting flowers, remove weeds, spill old or sick trees ... If everything is clear with the main part of such actions, then difficulties may have difficulty with a roll. To avoid possible problems, it is necessary to clearly imagine how to clean the tree.

1
The easiest way to get rid of the old tree is to seek help from specialists. For a small brigade fee, specially trained and highly skilled workers spires a tree preventing you and get rid of his barrels and branches. In addition, they can emerge the stump left in the ground, thereby freeing your site from the last trail of the tree ever growing on it. But if you pay for such work, you do not want anyone and completely confident in your abilities - you can try to do it all on your own.

2
To carry out these works, you will need:

  • saw;
  • axe;
  • long durable rope;
  • partner;
  • shovel and winch.

3
Start work follows from the preparation of the site. Determine the direction of the treasury, after which itching this zone. Remove all items from it that represent value for you and may be damaged by the barrel or the branches of the incident tree. Note that the zone of possible damage is much more physical sizes of wood, since during the fall it can change its direction or bounce aside by hitting the surface of the Earth. After the site is ready, try to climb the tree as high as possible and tie a long rope to its trunk - it will be needed to align the direction of the cut cut. At the same time, cut all the branches from the sides of the barrel to which the spoken tree will fall.

4
When with preparatory work it will be finished, you can proceed to the direct spilling of the tree. To start on the side of the fall at the base, cut the wedge - take the top of 45 degrees from above, and it should be parallel with the bottom. The depth of such a wedge should be approximately 1/4 of a part of the total thickness of the barrel. After the wedge is extracted from the trunk, start sawing the tree on the other side. At the same time, your partner should pull over the rope, adjusting the direction of its fall. This method is great for wood rolls entirely.

5
If, because of the arrangements located nearby or for some other reasons, the tree cut is not entirely possible - a stepladder or any other high staircase will come to the rescue. Consider it to the tree trunk, take it as above and cut it in parts. You should begin with a crown, gradually dropping to the bottom. You should not do too much distance between neighboring sleeves, falling down the half-meter log will bring much less damage than the two-meter. In addition, it should be remembered that in any case you can not drink sitting or hanging, since such a posture does not allow you to quickly react to a sharp change in the situation, for example, if the cutting log will fall directly on you.

6
The final stage is the destruction of the stump left after the spill. This can be done with a chemical or mechanical way. The first implies the use of potash nitrate or herbicides who kill the stump from the inside, the second - tractor, winches or shovels, with which the stump is simply irrigated from the ground.

Valka trees - a lesson is not from the lungs, takes away a lot of time and effort. But after everything is completed, you will be fully able to enjoy the result in the form of a large flat site, which was previously occupied by the patient, old or unnecessary tree.

Add a comment

Your e-mail will not be published. Mandatory fields are marked *

close