Not so long ago, you purchased new shoes, but did the sole bundled on them? If the warranty is not over, the shoes should be returned to the store. But when purchasing boots in the market, the seller does not produce a check and does not provide a guarantee. In this case, the shoes will be repaired independently.
1
Carrying the burst soles in two ways:
by gluing the lining;
the bay of the crack with rubber or a chip.
The first option will not save the shoes from the blotch, so it is only suitable for repairing summer shoes. If you need to repair winter boots, you will have to use rubber.
2
To upgrade shoes, treat the edges of the cracks of emery paper. Do not forget to pre-wash your boots. After that, the degrees of cracks. The rubber will not stick to dust. With a sharp knife, cut a piece of rubber from the old cycling chamber. The size of the strip must be twice the depth of the crack. Rubber strip Watch sandpaper and degrease with acetone or gasoline. Bend the boot, exposing the crack, spread the sections with glue. On the surface of rubber, too, apply glue only on one side. Insert the segment into the deepening of the crack. Put shoes under the press per day.
3
You can upgrade shoes using a soldering iron and kapron. To do this wash the shoes and dry them. Treat the surface with a degreaser. Heat the soldering iron and attach it to the crack. Rubber will start melting and fill in damage. Rubber soles will not be enough, so take a piece of capron and attach to molten rubber. Using a soldering iron, melk the Capron and fill it with a crack. Do this until all the recess is filled with a trap. Remember, warm rubber or kapron need a handle, rather than the sickle.
4
If the sole did not burst, but slightly erased on socks or in the center, it can be repaired using a lining. To do this, treat the surface of the sole, in the region of its thinning + 2 cm emery paper. Decrease solvent. Cut out a piece of rubber or polyurethane, in shape equal to the damaged place. A slice that will be glued to shoes, treat sandpaper and degreased. A piece of polyurethane should have a different thickness. That is, the maximum thickness should be in the place of the greatest damage. And the thinnest plot should be glued to the sole with normal thickness. Sketch the soles and the lining. Hurry up the items and leave them under the press until complete drying.
5
As adhesive, use a special shoe composition or adhesive. This is a substance that is selected depending on the properties of the sole. On the packaging with the adhesive, it is written which materials of them can be repaired.
6
If the sole spacked in the collapse area, it is not enough to apply glue to places that are poorly adjacent to the skin of the shoes. For repair, it is necessary to carefully pose the sole and remove it to the damaged place. Now you need to handle the sole and bottom of the shoe with a file or sandpaper and degrease. On shoes and soles you need to apply glue and press well. Do not put dumbbells and other items on the skin, they can leave dents.
Perform work on the balcony or on the street, since the adhesive pairs may contain poisoning substances.
0
1345
