When the snow comes down and the earth turns into dirt, there are dull autumn rains and everywhere puddles, there is no better shoes than boots from rubber. Only there are cases when you come to a shard glass or caress for the wire, and everything is puncture or cut. It seems like good boots, and the water skip. But you are not in a hurry to throw a thing, try to repair it.
1
To repair rubber boots, you will need: rubber glue (better than Red Sun or moment), grater or abrasive paper, scissors, raw tires, little gasoline.
2
First you need to find the place of puncture or cut. If no damage is visible, then you should twist the boot top so that the air is squeezed under pressure. The boots omit in the pelvis with water, and where bubbles go, and there will be a core or puncture. In the puncture you can insert a pointed match so that the place is not lost.
3
Repair boots can be done in two ways - hot and cold. Each of them has both its advantages and disadvantages. Consider both. To repair a hot way, a volcanizer will be required. Repair of boot with a volcanizer requires some experience with it. It is necessary to twist in gasoline raw rubber (10 minutes), then put it on the hole and hold the vulcanization press. Turn on the volcanizer for 25-35 minutes, then turn off to make it cool to normal temperature, and then remove the press. As a result, you will get a quality repair of the defect.
4
Cold way simpler. Before repairing boots, worry well and dry. This method requires that the thing is clean. The damaged area must be carefully cleaned with abrasive paper. If the top is broken, then you can pull the edge of the rupture, flashes thread, then go to the next step.
5
The pay will be able to make rubber itself. It is necessary to clean it from the inside evenly, and from the outside - the edges should be more subtle. You can use ready-made patches from the wheel repair kit, from there and glue can be taken.
6
We apply glue to the damaged portion of the boot and pay. Let me dry for about ten minutes and applied the composition again, we let me dry about twenty and neatly, without touching the glue, we put the pay. After putting a boot with a patch under the press for two hours. You can press the table with a foot. When the patch is securely stick, it needs to be treated with fine abrasive paper.
Thus, with the help of our tips, you can make the repair boots yourself and save on the purchase of new ones.
0
1652
