During the cycling season, when you have to ride a lot, annoying trouble happens - puncture of the camera in the wheel. On the roads sometimes there are quite a lot of garbage, and how do you not try to be attentive, someday, and you will roll the wheel on the glass fragment or acute piece of iron. You can find a service and take the camera there, but the real cyclist should be able to fulfill such work itself! Here we will try to give several practical advice to beginner cyclists, how to correct the camera.
1
The first thing you have to do is to purchase Repair Kit for Camera Glu. This set includes repair patchs, glue and grater for clearing the camera. Buy also fetters for stringing wheels (plastic), well, and keys for removing the wheel. Keys pick up for your bike individually.
2
When you puncture the camera in the wheel and you want to make the repair yourself, you first remove it. To do this, the bike must be flipped over, and unscrewing two nuts, remove the wheel from the frame. Typically, the wheels in bicycles are removed without much difficulty. After that, proceed to the scoring.
3
Before you focus, carefully inspect the tire, it can get stuck what caused your wheel. And if you do not remove it, then you can damage the camera even stronger when bothering. Then unscrew the nipple from the nipple. On the nipple there may be a nut, fixing the nipple to the line, if it is - unscrew it. All these small details set aside so that they are not lost.
4
If the bus fails with his hands (most is not tight), then use the installation. Get them under the edge of the tire, centimeters in fifteen each other, and pressing down, remove part of the tire from the rim. And then you get one side of the tire from the rim completely and remove the camera.
5
Now in the chamber you have to find the place of damage, for this tighten the nipple and pumped the camera. You can try to detect the puncture visually, but it does not work more often. Then lower the pumped chamber in the pelvis with water. Upon air bubbles you can easily find the place of damage. Notice where it is. You can break it with a handle, and you can insert a pointed match in it. Then let the camera dry and lower the air out of it.
6
Place damage at the camera Clean the grater or sandpaper. Then take the boost and remove the foil from it. After that, on the pay and place of damage on the camera, apply a layer of glue, let him dry by seven minutes and apply another layer. When the glue is dry in five minutes, impose a pay on a damaged place in the chamber and put it all under the press for two hours.
7
While the camera dries, remove the tire from the rim and carefully inspect it from the inside and outside. There can hide a piece of thin wire or paper clips from a stapler and in general anything. If you do not remove it, it will damage your camera again. Before you put the camera, pumped it back and check it in water.
8
When you started to focus the wheel back, then first put one side of the tire on the rim and insert the camera. Then carefully dress in the rim to the second side. Try to wear it with your hands, and if it does not work, help yourself by installing, but watch the camera is not damaged. After that, pumped the wheel and put it in place.
As you can see, there are no special difficulties in repairing the camera. And even a novice cyclist can take it, the main thing is not afraid. As they say, the eyes are afraid, and their hands do.
0
5543
